Recent content by DennyDoler

Nice tag.....

Rob, Come by the shop and ill give you a hand with it.

If you copy it, it won't fit anything.

I looked for the post in the Discovery section asking about Disco rear door tire mounts and I think it was lost in the server move so Ill post it here. I have finished designing a new Disco rear door tire mount that bolts to the rear door using the stock hardware. It moves the tire up 3"...

I have an older set of the rte 5" springs that have always been very firm and rode great.

If you decide to do it let me know. I'm looking at going the other direction with my RRC. I will trade you all of the needed parts to swap if your interested in trading them.

I assumed you wanted the front, I didn't get anything from the rear but I can if you need it.

The transfer case flange is at 6 deg, the shaft is at 17 deg and the pinion flange is at 16. This is all at rest on the ground. Hope this helps.

I'll try to get the numbers from my truck tomorrow. '03 with 4.5" front/4.75" rear with stock arms, TW DC front and rear with extended splines and no drivetrain vibes.

Hard Labor Creek Fab Slidershttp://www.youtube.com/watch?v=sDJCkFfZr8Q&sns=em

http://www.youtube.com/watch?v=sDJCkFfZr8Q&sns=em

My kids have been playing basketball with that check for a while now.

No, I believe there may be some cheap fucks running it also.

Why would need to run a 2.5" OD steering bar? I don't even believe that it would clear the diff or radius arms.

The first part of this question has endless answers, but would include taking time to properly wire and or fuse any electrical devices you add to your ride to prevent electrical fires, maintain your brakes to avoid brake fires, check and replace worn hoses that carry any type of petroleum based...