I've always been a fan of the pper end Pioneer line with the OEL displays. I've used them in a bunch of m show cars and daily drivers and never had an issue.
Actually, that was the only one I COULD read with the top down on my Saleen.
Ok, I can't seem to figure this out. My A/C works fine for a couple days and then randomly blows the fuse in the underhood fuse box. It's the recommended 30amp fuse I'm using. A/C has good pressure, and is ICE COLD when it works, and all the connections look good.
This is on a '94 D1.
Any ideas?
We had similar issues with Toyota 1Jz engines, as well as a few other all aluminum engines. We were able to cure most of this with the purchase of better quality head gaskets, and a good set of ARB studs to replace the stock head bolts. we also used a slightly higher bolt torque(partly for the...
It's sitting in my driveway, not to mention the dealership I was working at before going independant serviced the local Rovers.
I guess it just made absolutely no sense to me how shops were charging more than we would have at the dealership. Our FR book quoted 8 hours for R&R heads, which is...
So what I'm gathering from you is that, even though these trucks are being touted as very tough trucks, they are built with crap components and junk parts??
Gotcha.
Now, I was going to just apologize and say ok, but you had to dig all those other posts up..
So.... Do you really think it's...
Believe me, I've done cars and trucks of all kinds. I've been doing this for a day or 2. I haven't had to do one in a Rover yet, but I bet dollars to donuts I've worked on things WAY more complex, cars and trucks alike. I've done a few other things on rovers, just not a HG swap.
Also, what do...
I see what you guys are saying, but I deal with similar stuff all the time. First off, I live in Wisconsin. Find a bolt here that isn't rusty. Aluminum blocks and heads are common on pretty much any vehicle nowadays. I guess I just can't see the complicated part of these vehicles, but I'm used...
Re: How much is the standard cost for head gasket replacement including heads macining?
How the hells is it taking 14 hours to do the head gaskets!!!! Christ, I can do them on a 4v Mustang Cobra in 9, and that's taking it slow. I can do the things on a newer 300ZX Twin turbo in less time than a...
Check out www.cheaphumidors.com
great guys, and great to deal with.
Also, check out the Cigar Pass Forums, and Club Stogie. Both have excellent info on Huni's.
Above all though, make sure whatever you get is lined with REAL Spanish Cedar.
Super tech is actually recycled oil FWIW. It's re-refined by a common company(can't remember which one, Pennzoil maybe?), and distributed to Wal Mart in Super Tech bottles.
edit: It's Quaker State.
Megasquirt itself is around $300. It is very much DIY though. It does have a very good support network.
As for tuning, you can either run a base map from another person in the network and tune it on a dyno, or buy a WB 02. I have a WB already in my toolbox, since I do a lot of that kind of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.