Recent content by mokemorgan

PS when I said I metered the leads... I had metered between the two pos leads to see if they were common, but since I used an old analog radio shack ohm meter with low (at least questionable) battery I wasn't sure if it was reading correctly. It appeared as though they were common (full...

I did what you suggested and used a pos from one side and the neg of the other... That way, it's just an impedance issue which can be adjusted with the processor, and I'm not burning out the HK sub-amp. It sounds great, so I am happy with that. Thank you for the feedback and input. Next for me...

Thanks for the reply... What I was asking is: are the two sets of wires common? I mean do they both join at the other end? OR, are they the same from the amp? I only have 1 input into the device (yeah, I could buy a second unit @ $139.00 US, but would rather spend my money on CDs. ;-) I am...

Hello I know it's been a while since you did this, but I am curious if the 2 subwoofer cables (wires) from the stock amp are common. I could dig around, but hopefully you already know and can share. I have a single input (high-level) processor that I want to use, and I thought I could twist both...