Recent content by n8thgr8

Yes, the seat foam base. http://www.roversnorth.com/ProductDesc.aspx?code=EXT321-4

Hey guys! I have two Exmoore D1 seat bases sitting right here. I had my seats for my LSE redone and ended up not needing them. I paid $90 each for them from Rovers North, they've never been used, (just dusty from sitting in the upholstery shop for a while) Price is negotiable. hit me up if...

I've been rooting around with my o2 sensors, and I've discovered that there are several loose connections with wires into the connector plug. Is there such thing as a replacement plug on the ECU side?

I think it's pretty safe to say that almost nobody here is running plastic brake lines. Bad

You must have to do that with at D2 as well. Replacing the sensors in a D1 is mostly a snap. The ones that are in front of the Cats are a little tricky, but just reaching behind the engine and with a little dexterity you can snap the new sensor into the plug. All my sensors are brand new, I have...

haha, that only partly explains why it made no sense to me. I appreciate your help though.

Ah. I'll have to admit that when it comes to electrical problems I'm not very good at them. FOr a long time I've had P1187, a bank 1 problem. But at the time my scanner was so basic I didn't have any other information. But the symptom is horrific gas millage. mixing WAY too rich. I have since...

So I've been having problems with my o2 sensors for years, and I'm finally figuring out what is going on with them. It would appear that there isn't any voltage, and only 1 of the 4 sensors is reading. SO, now that I have THAT critical bit of information, my question for you guys is this... What...

I started using the Foseal dongle, with a couple different apps just a couple weeks ago. It doesn't do ABS sadly, but Dashcommand and OBDII CarDoctor apps work pretty well. (I think I prefer the free carDoctor app)...

Curious, why wouldn't a 98 be oBD II compliant?

The door seals will interchange. (not sure about the rear door though)

you didn't say what kind of truck you are talking about

Thank you guys! Guam is a small island, and in a couple of days I'll have a friends car to borrow. So, it'll just be to get it home and to the shop where I can get it done when the part gets here. Thanks for the handling tip too. I hadn't thought of that. As for the stress on the front, I have...

So, U joint on the transfer case end of my rear drive shaft grenaded the other night. I was only going like 5-10 mph, so I managed to avoid a LOT of damage as it dug into the pavement. New shaft on order now... Can I just remove the rear shaft and use the truck in 2wd? what are the consequences...

I think special order is the way to go, ebay maybe or one of the guys here could get them. Most locksmiths I've talked to don't have them. They might have a key that would fit then length, but I've heard of some of those not fitting at the shoulder and unable to be pushed into the ignition for...