my truck doesnt have an ECU only an EFI computer and that only gives the EFI system how much fuel is needed and the mixture of air and fuel needed to start thats why i know it must be the fuel temp sensor or the coolant temp sensor because if its not reading the correct temperature from the...
i was wondering if it is more important to replace the coolant temperature sensor or the feul temperature sensor to fix my cold start problem. im not sure whether one is more important than the other.
well id have to say that it didn't work out only because the cast on the 94 D1 diff was different than that of the 10 spline diff. the 4 mid section studs on the 10 spline axle housing were too short and when the 24 spline diff was set in place, the 4 mid section studs did not poke through...
ok so heres what happened. I have an 88 RRC and the front right CV Joint went out on it. my brother is doing a dana 60 axle swap front and rear for his 94 D1 and has his old front axle out laying in the yard. my question is, can i take the 3rd member and axles off his old front axle and put...
I've yet another problem with my 88 RRC. I tried to search but couldn't really find any thing. I powerwashed the entire engine bay today as it was full of mud and grime. After I washed it, I took the air compressor to it as well as a blow dryer to try and dry the connections as best I could...
well I've checked all of the connections countless times and everything seems to be in order. I also held a blow dryer up to the dizzy for about 10 minuets. I'm pretty sure the dizzy isn't wet anymore. There was a couple problems with the coil connections, turns out that the connection tabs...
I've yet another problem with my 88 RRC. I tried to search but couldn't really find any thing. I powerwashed the entire engine bay today as it was full of mud and grime. After I washed it, I took the air compressor to it as well as a blow dryer to try and dry the connections as best I could...
i'm having the same problem, ill turn the truck on and it will idle high but sometimes it will idle fine but as soon as i turn it off and start it up again it idle way to high and like 1100 or 1400 rpm. i too just replaced the stepper motor so....... how do you reset the values?
88 RRC
Does anyone have a front cover that wound fut an 88 RRC???? I've tried some places but nobody returns my call :( . the highest i can fork out is $200. if anybody has something send me a message.
Thanks,
Mike Ford
'88 RR classic
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.