Recent content by robbyb20

  1. R

    Start up oil pressure, takes too long for the low pressure light to go out?

    Anyone have a recommendation on an oil pressure gauge with the correct fitting OR the size of the oil pressure sender fitting so I put something together? The lighter oil sped up (5seconds 30s weather) but now its a bit noisier on initial startup. once warmed up its good though. May as well...
  2. R

    Start up oil pressure, takes too long for the low pressure light to go out?

    Speaking of filters, had on wix filters for about 2 years, had a K&n one on previously and now have a mobil one filter on. I just changed out the 15w40 for 10w30. Will have to wait till tomorrow to see what what its like since I changed it after gettting the engine up to about 100f. On...
  3. R

    Start up oil pressure, takes too long for the low pressure light to go out?

    Hey Terry - Out of curiosity, how long does it take for the light to go out on a cold morning? Once warmed up, parked and restarted, how long then? I also struggle with slow pressure buildup on the first start of the day. During summer(80-100), its 3 seconds. In winter (in the pnw), its...
  4. R

    Purge valve hose clamps…

    Thank you! I’ll give it a shot when I get home.
  5. R

    Purge valve hose clamps…

    How the F do you remove them? I’ve not had to work with these before. My intuition says to squeeze them to somehow unclip them but nothing works. I can cut them off with a dremel but I’d rather learn. whats the best way to remove?
  6. R

    Intermittent brake failure

    You wont get a code for ABS faults thru OBD. Youll need to use the blink method WaltNYC posted above to get those codes. Ive had my ABS come and go will activate at low speeds but never had barkes complete go out.
  7. R

    AEL Fuel Pump

    Looks like its not too bad. 34psi with key on.
  8. R

    AEL Fuel Pump

    Engine is running with those #s
  9. R

    AEL Fuel Pump

    What about 27-28psi? I just swapped out the fuel filter and no change. Ordered the pump listed above just in case.
  10. R

    Heavy shielded wires

    Big Heavy Gauge is power from Battery, Smaller is for starter solenoid, Plug is for Knock Sensor. ALL on that side under the heat sink. If you already have a heavy gauge wire coming from the starter, you sure its not ground?
  11. R

    Help sourcing replacement Evap Purge Valve for D1

    Ill take you up on that offer if you have more to spare.
  12. R

    HELP No dash lights

    Thanks, I should have asked it differently. I know I can unhook them but would it potentially have an effect on my auto-dimming for my dash lights/stereo? It feels like something is causing it to think the lights are off and tripping to dash to brighten but the headlights are never turning off...
  13. R

    HELP No dash lights

    Can i Just unhook these? I have problems with my lights dimming randomly and I noticed the connection for these is not great. Curious if it will have any effect.
  14. R

    Bleeding Brakes - no fluid out of both rear brake lines

    In case anyone wants to reference this in the future, here is an update/resolution to my issues: Replaced Prop Valve and bled system. Overview of Results of testing from suggestions above: Fluid coming out of master cylinder (4 and 14 per Rave Diagram) Fluid coming out proportioning valve...