Recent content by ronward

man...I tried it all Sunday afternoon. Shocks are tight top and bottom. Normal play in the bushings, but I tried to tighten up everything under the rear end. I inspected the exhaust again, no probs there. I crowbar'd the springs top and bottom, they are seated properly. I took a rubber...

I will try all these suggestions...sure sounds like the rear door though...weird.

I have RTE 2" HD lift with Bilsteins on my 2004 DII, along with RTE rear bumper and gas tank skid plate. Just recently I have been experiencing a knocking sound from the rear of the truck on bumpy pavement or body roll. At first I thought it was loose rear bumper, so i tightened it up. Sound...

Perfect. Thanks worked out fine.

I have RTE's HD rear bumper on my Disco II and it was installed by Steve and his crew in Midlothian VA back in Dec 2006. A loud squeak or pop has developed on the rear drivers side as the frame or body flexes or i go over a bump or pothole in the street. Could be from a loose bolt. Anyone...

double post...

lol...

Sure, I don't camp on snow or in zero degree F weather. I didn't think that was our original poster's concern.

The problem with inflatable beds is they are on the ground. Get a Big Cot XL and lay a Thermorest closed cell self-inflating pad on top of it and you not only have a great big cot to sleep on 2 feet off the ground, you'll have a nifty place to sit on to put your boots on, and room to store your...

bluegrass and Grateful Dead around the campfire for me.

That's the one Mike. Thanks.

Trying to help out a friend with a new (to him) D-90. Anyone have the dimensions of the do it yourself D-90 seat risers that were once posted here? I fabbed up a set for my 90 three or so years ago and now I can't put my hands on the specs. Anyone? Thanks in advance... -Ron

I must have a non-standard grease gun then. The long needle-like piece is what doesn't fit. I'll figure it out with shrams help though.

Got Bill's rebuilt front drive shaft for my 2004 DII and it came with a grease fitting made to work with the low-profile "zerk" fittings on the new u-joints. Anyone know how this piece is supposed to attach to a standard grease gun?

Quit screwing around...RTE is the answer.