Bolt everything up "loose" so it floats a bit then tighten the RH and LH downpipe flanges (use a small amount of high temp RTV on these). Next, tighten the manifolds, followed by the ball type muffler connection. The last thing should be the clamp for the two sections of the y-pipe.
I just went...
I read this. DII has M14 lugs.
Proper Torque (tightening)This is also very important. Over tightening lug nuts/bolts can fatigue the vehicle studs or lug bolts. Use the SAE recommended torque listed below as a guideline for passenger cars and light trucks;
12mm, 7/16″, 1/2″ = 85 ft/lbs (+/- 5...
Front driver side coil spring on 2000 DII. There's nothing obviously loose, drives fine and sits level. The springs are Terrafirma HD +2 and are about 5 years old.
It's like the axle isn't straight but all the radius arm bushes seem ok. Maybe I'll exchange the front springs from side to side...
https://www.ebay.ca/itm/New-Front-Wheel-Hub-Bearing-Assembly-For-Land-Rover-Discovery-Series-II/172679176677?hash=item28347b21e5:g:97cAAOSw0hlZHAvL&vxp=mtr
Are these hubs any good?
I put a Proline hub ($300) on the RF about 2 years ago and it just failed. It was the most recently replaced hub...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.