I posed this on defender source as well...
Over the past few months I have been working to get the gremlins out of my daily driver 1995 RRC SWB
I had a wet/morning start issue/ driving in wet weather stalling issue that was eventually resolved with a new distributor assembly from atlantic...
I posed this on defender source as well...
Over the past few months I have been working to get the gremlins out of my daily driver 1995 RRC SWB
I had a wet/morning start issue/ driving in wet weather stalling issue that was eventually resolved with a new distributor assembly from atlantic...
I have a 95 RRC with a cracked plastic disc that is used in the lock assembly on my driver door. I have a close up photo of this. Anyone know where I can source one? Or do you have one around? The rest of my assembly is fine, just this cracked ring.
--chris
I have a 95 RRC 3.9 that is a hard start or no start at all.. just cranks when the weather is foggy or excessively wet.
I have ran a hair dryer on my open distributor and validated I have spark. This didn't seem to work.
I'm looking for pointers on where to look. I'm good at following...
I took these off carefully, sanded them, painted them, cleaned the shit off my d2 (fscking 3M!) and then just sold the truck w/o the flares.. guy didn't want them.
So now they are offered to dweb.
75$ obo with free shipping to north america.
thanks!
I just want the actual leather covers.. i don't care if it's worn, jacked up, (rips are ok if they are manageable)
I want these seats so I can destitch them and make a template for new leather. A break on the price would be nice based on the condition. Really I'm hoping for someone parting...
I need the metal assembly and a few of the internals for a rear passenger door (driver side) of a 95 RRC SWB.
I bought one already but it apparently was for a right hand drive drivers door (key hole and the wrong side of the car!)
have one?
shipping to 32548
also need a passenger side...
Pic included.
I have a leak that is intermittent but usually after sitting during a heavy rain. It appears to come right out of this grommet/gasket that goes through the firewall. Not sure where it comes out because the engine compartment is quite jammed and I'm having trouble finding that...
i need the front driver side and passenger side of floor carpet and insulation/padding.
it's a 95 swb if that matters
tan colored carpet.
I am open to non-showroom condition. I just need something reasonable.
--chris
Sitting in a drive through yesterday I started to hear a ticking. couldn't tell if it was under load as well, but definitely there at idle.
Ticking continues after warmup, roughish idle. It's not really that rough but it's not the smoothness it was a few days ago. On acceleration from a...
Looking for the trim pictured in the linked photo.
Also interested in passenger side heated seat switch.
http://www.portland-deco.com/IMAG0266.jpg
I do not need the switches or the clock.
I would prefer one that has all tabs and isn't cracked (like my current one)
Shipping to 32548.
Looking for the dash trim that surrounds the heater/radio/switches .. I want to include the small trim piece below the radio that holds the LED (including the LED) Seems whoever installed this aftermarket radio fscked up the install and glued that trim piece back on!!
Also I need the connector...
http://www.hi-lift.com/accessories/4xrac.html
new in package.. just decided on a different route.
20$ plus shipping.
discoweb keeps puking on a my image upload.. shoot me a PM if you want a picture of it in the package.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.