I have a 95 Discovery with this box labeled LNRA32CON connected in the trailer wiring harness. Who knows what it is or what is it supposed to do?
Thanks!
I was a little disappointed (in the Rovertym) to say the least.
Stopped to greet a fellow hunter and parked down the hill below him. As he hopped out the mule took off and the rest is in the pictures.
Who can help me with this? I need to install my rear ABS sensors and it says to use silicon grease. The auto store had no such grease. Can Dielectric grease be used instead?
How do you remove the snap rings that don't have the little holes for the snap ring pliers? I'm trying to replace the heims in the Bilsteins with bushings and one snap ring comes out easily. I am unable to remove the other one because no holes. :banghead: Any suggestions?
I have a window that has come off the track in a 98 P38. I was trying to remove the inside door handle so I can remove the door panel. I removed two screws but the handle doesn't come loose. What am I missing, is there more than one screw in each hole? Is there some trick to removing the handle?
So I go for a little ride in the snow yesterday and I hear a loud pop.
The next thing I know a crack is shooting across my windshield. It just kept going and going. :mad:
You guys just had to talk about how good that windshield was is the parts truck! You remember, something like "Hey...
I was just flippin channels and came across some teams of people driving around in rovers. Not sure what's going on yet but one of the team's rovers just broke down. Does that surprise anyone? :smilelol:
Whenever I shift the transfer case (95 D1) into low range (2or 4 wheel) the signal tone comes on and never goes off. The transmission was just rebuilt and everything reinstalled, so they obviously have something wrong. I took it back to the shop.
The mechanics are stumped they thought that...
Working on some minor vibration issues since the new lift on my 95 D1. Went from OME HD to 3" RoverTym with isolators top and bottom, replaced radius and trailing arms and installed a new front DC driveshaft.
I primarily get vibration when I left off the gas. The u-joints on the rear shaft...
I know lots of you guys don't like ABS, but I would like to keep it working. I've got a 95 Disco.
I had a wheel bearing go bad, which in turn destroyed the stub axle and the abs ring and possibly the ABS sensor. The sensor appeared to grind about 1/8" out of the abs ring so I'm assuming the...
My disco just started making a strange squawking noise whenever I try to start it. Almost sounds like a weak horn. It sounds like its coming from the top or top back of the engine. Doesn't do it after it starts running. Any ideas?
So I'm walking down the street in Vegas last night and a nice F250 pulls up to the light with RVRTYME for plates.
My first thought... That ain't a rover!
My second thought... Wonder if that's for towing the rover?
My third thought... I'm thinking about rovers too much! He's probably...
I am trying to install a electric brake controller on my 1995 Discovery. The trailer is setup with standard 7 wire connector. The RV place wanted around $400 to set it up for me including their least expensive controller. They said there was an extra hour surcharge for wiring a Discovery. A...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.