Search results

If anyone is interesting I bought these hub centric spacers from ebay...

I found hub centric spacers on ebay and he lists the spacing as 5/120.65mm. Is that close enough for a DII wheel?

I just installed a glow shift pod with an oil pressure and oil temp gauge. I have it all wired up and it works accept for one feature. It has a dimming feature that needs to me wired to the headlight switch or to the positive "12 volt switched headlight source". I was going to remove the...

I need to get to my headlight switch to install a gauge (so it dims when I turn on the lights). I don't have a steering wheel puller but will buy one if needed. Are they really needed on these trucks or can you get your knees under the wheel and pull like on some vehicles? Also is the puller...

Just did my front engine mounts on my DII and the drivers side mount especially was quite tough to access. Here are a couple tools that some may find helpful if you must tackle this: 1) 18mm blue point ratcheting crowfoot...

I'm going to purge and refill my R134a. I have a set of gauges, vacuum pump and an empty propane tank to empty the old freon into. I'm not sure the total mass of R134a needed though the Rave CD mentions 180 mL of oil but not volume or mass for the freon itself.