Search results

good point, i failed to mention that i replaced it I also switched the ignition and fuel pump solenoid along with a known good ECU

coil checks out also

1995 RRC with Unilite and Mallory coil. The rover was jumped with the cables crossed and the battery caught fire. No comments on this... My son will never let someone else connect the other side of the cables again. Now i have no spark. I have replaced the 100 amp fuse and had the alternate...

Will Great, what do you want for them? Stephen

I am looking for an air intake hose (MAFS to Plenum) for a 1995 RRC SWB. I also need the two windshiels wiper covers that hide the mounting bolt. Thanks, Stephen

have a Hannibal for a RRC. It is missing the mounting components. I have called Hannibal USA and reached out to the headquarter in South Africa to order the parts with no luck. Does anyone have the parts or any ideas on how to replace them? Thank you, Stephen

I found the issue. The plenumm had a leak in the base. I corrected the issue and then reset the timimg and base idle. All seems well.

Would you be willing to sell the cross bars and J-bolts? I have a rack but am missing those parts.

It smells like fuel.

It is... I will try to find one and see if that corrects the issue

Here is the background?I replaced my tired 3.9 in my 1995 SWB with a 4.2. It has a Mallory Unilite and Mallory Coil, new stepper, plugs and wires. It had a rough idle, but at speed it performed well. I had a set of new ford injectors and installed them to try and address the idle issue. Now it...

Doug Did you have luck with PAC SOEM 4? Stephen

Thanks, I will give it a try...

I can not figure out the wiring for the coil on my 95 RRC. Here are the details 3.9 with Mallory Unilite and Bosch coil. I am getting no spark from the coil to the discs. I have the two black and whits wires that run through resistors to a single black and white wire attached to the coil...

I can not figure out the wiring for the coil on my 95 RRC. Here are the details 3.9 with Mallory Unilite and Bosch coil. I am getting no spark from the coil to the discs. I have the two black and whits wires that run through resistors to a single black and white wire attached to the coil...

do you still have this engine? Also is it a 3.9, 4.6?

I do not disagree it has gone through a slow rebuild by the PO and myself. At this point it has the following new parts. heads, main and rod bearings, oil pump gears. all of the cylinders have good preassure and with the new knock I wonder if I just replace the cylinder or go ahead and pull all...

The main bearings were replaced last year and still look good. We isolated the oil cooler and that has kept the light off. Have you seen this before? Also isolated the engine noise to the number two cylinder. when you pull the plug on that cylinder it clicks like heck. I had the recomendation to...

Ok, it has been awhile and here is where we stand. The engine had bad rod bearings and those have been replaced. The timing is now correct and was originally off considerably. The main bearings are good. The top end is getting oil but the light still flickers at low RPM and there is still a loud...

Carlos Thanks for the reply... I rebuilt the top end a month ago. New heads and gaskets hoses etc. It went well no leaks or issues yet. I do think the bearing rebuild is past my abilities from a tools and knowledge standpoint. What would a shop charge to replace the bearings? I have a quote of...