Search results

1995 RRC with Unilite and Mallory coil. The rover was jumped with the cables crossed and the battery caught fire. No comments on this... My son will never let someone else connect the other side of the cables again. Now i have no spark. I have replaced the 100 amp fuse and had the alternate...

I am looking for an air intake hose (MAFS to Plenum) for a 1995 RRC SWB. I also need the two windshiels wiper covers that hide the mounting bolt. Thanks, Stephen

have a Hannibal for a RRC. It is missing the mounting components. I have called Hannibal USA and reached out to the headquarter in South Africa to order the parts with no luck. Does anyone have the parts or any ideas on how to replace them? Thank you, Stephen

Here is the background?I replaced my tired 3.9 in my 1995 SWB with a 4.2. It has a Mallory Unilite and Mallory Coil, new stepper, plugs and wires. It had a rough idle, but at speed it performed well. I had a set of new ford injectors and installed them to try and address the idle issue. Now it...

I can not figure out the wiring for the coil on my 95 RRC. Here are the details 3.9 with Mallory Unilite and Bosch coil. I am getting no spark from the coil to the discs. I have the two black and whits wires that run through resistors to a single black and white wire attached to the coil...

I can not figure out the wiring for the coil on my 95 RRC. Here are the details 3.9 with Mallory Unilite and Bosch coil. I am getting no spark from the coil to the discs. I have the two black and whits wires that run through resistors to a single black and white wire attached to the coil...

I have a 1995 RRC SWB with a 3.9. that I am trying to get running. I have done a few things outlined below and have a few issues to address still. Just looking for a few recommendations on next steps. What has been done: New Mallory distributer with champion plugs and bosch wires and timing set...

Duplicate thread

I have a 1995 RRC with the the origional 3.9. I have a front cover but am still getting a lot of oil coming from around the crankshaft. I have checked the HD and it is not cracked but i did find a bolt jamed in the underside rear lip of the HD. It did not dammage anything that I can tell. I have...

I have a 95 RRC with a 3.9. I purchased a 4.0 from a 1987 RRC and intend to use it a a replacement block as my 3.9 has a bad cam and bad crank bearings. I have a few questions... My 3.9 is a B suffix block and the 4.0 is an A suffix. Will this 4.0 be a direct bolt in after i transfer my front...