Search results

2003 Discovery S, 72k miles, epsom green, 2" OME lift and shocks, SS braided brake lines, trailer package, locking TC, 5 new 275/75 R16 Kumho with 200 miles on them, spare relocated plate, all the gaskets on the top end replaced, new water pump and t-stat (did not get hot, I had front cover off...

2003 Disco S, 72k I have done step B repair and lights went off. Installed new braided hoses when lifted, akibono pads all the way around. Light returned a short time later with a RRW poor connection code. I checked ohm reading and it was in spec. So I swapped the RRW with the LRW sensor...

P1590- Rough rd--new 045- switched sensors determined it was sensor. New sensor spliced and soldered. still there. Cant be hub, sensor was switched side to side. P1412 & 15- SAI valves. Mechanic fixed a vacuum line reset and they were gone for a couple days. After new wheel sensor they showed...

I have a valve tap that showed up after I put the top end back together. Engine was dirty so very possible its just carbon that got knocked loose. I am running rotella. Anybody ever try running cam2 to wash out the engine? anyreason not to try it?

I had a code for RR wheel sensor. Swapped the sensors and the code was then on the L. So I ordered a new sensor from AB. Problem I have is that the new sensor has about 20' of wire to go back to the SLABS. I really dont want to run the wire all the way back and locate the connection. I tried to...