FOR MORE PHOTOS https://houston.craigslist.org/cto/6022204062.html
1996 Land Rover Discovery SE7
190,000 Miles.
***UPDATED WITH MORE PHOTOS***
This has been my weekend wheeler for some time, but family commitments and other obligations leave little time for fun hobbies. This is an excellent...
I have been chasing down this idle problem for a while now and I think I have established a pattern...
Cold start - Starts up fine ad runs until it gets warm. Then it dies when in drive and foot on the brake. it will run in P/N or by goosing the throttle a little. NO CODES.
Warm Start -...
So I am doing the rear drive shaft upgrade on my 96 disco.
I am having MUCHO trouble getting the centering pin off. It's stucker than shit! I have been hitting it with PBblaster regularly for a week, I tried propane heat, and a special puller tool that a friend made.
THe tool is a piece of...
My diffs have been leaking from the shaft since I got the darn thing. I am getting ready to rebuild my drive shafts so I may as well address the diffs.
I know there is an outer seal and that has obviously failed. But is there anything on the inside I should be worried about? Any internal seals?
To make a short story long.....
We had a shit lot of snow on Friday which made me happy to finally put the Disco and it's locking central diff to the test...
I threw the beast into Lock mode (high) when I left the office and drove her home. I didnt notice anything different in the ride in...
After a long and hard search, I finally found the one Land Rover that I have coveted for many,many years...
It's a 1997 D110. It has 0 miles and appears to be assembled in Thailand. I have no idea if it is a TDI or V8 and it only cost $1.19! What a steal!
So the Cheese-Dick who was the previous owner of my Disco stuck an after market radio in it. It looks like he bypassed the amp, but the speakers are using stock wiring. Tweeters no longer work and the antenna has disappeared..
But the problem that I am trying to solve today is that when the...
I need new sway bar bushings. One of the bushings that attach to the frame is complete toast....
Poly bushings are $60 for the set. Stock bushings are $15.
Given that this is my daily driver and all around winter beater-with-a-heater, does it make sense going with the poly bushings for this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.