Search results

2004 DII I did a SAI->Non SAI swap a while ago, finally getting around to chasing down the EVAP stuff. I swapped out the fuel pump for one with the leak detector sensor. I've got it all wired up, and patched in to the ECM on the proper pins (per the Electrical schematic). I've measure the...

http://www.grainger.com/product/APPROVED-VENDOR-%20-2NNZ8?cm_mmc=EMT-_-OrderConfirmStandard-_-GuestOrderConfirm-_-sku&cm_em=jaredsydneyjames@gmail.com&RIID=96922726&SG=NULL&OAA=NULL

Yeah. Bring all of what up just said next week for our trip.

Noticed something on the scanner tool. when I look at the "Heat O2 DS" it fluctuates from Off to On and back and forth. "Heat O2 US" stays "On" all the time. When I look at the Heater Ready state, both US and DS are in "Ready" mode. Looking at the voltages on all 4 sensors, they are all...

2004 DII Swapped the motor and getting a bunch multiple misfire codes. p1300, p0308, p0304, p0305, p0307 I drove for 30 miles, ran fine but the codes were still there. I pulled the plugs and they all looked identical... same burn pattern. I cleared the codes, and drove for 130 miles with no...

Thanks... Actually by accident we figured this out as well. The connector on the rear o2 (non-harness side) is the same as the front o2 harness side... So I clipped the connector off the old rear sensors and used them to replace the front harness side.

SAI or Non SAI?

Figured I could do that, but whats the name of the new housing so I can order one?

Does anyone know what the name of the connector for the O2 sensors is called? The orange one that is on the harness side of the wiring, not the O2 side. One of mine broke and I'm looking for a replacement. Or if someone has a parts car that could clip one and ship out. Thanks

Proud Rhino? http://www.sabisabi.com/blog/wp-content/uploads/2012/05/Rhinos-Mating-5.jpg

Assuming SAI.. If not, how much for the ECU shipped to 75075?

I could be wrong. But the claim on the link you provided, 42k Break strength and 10.5k of wll, is the rating for a straight pull of Amsteel. Not in the knot tied config as they show. Do those numbers still apply when configured in a basket, like it is shown around a tube? I use one of these...

Educate me then. I'm not opposed. I'm just saying. My experience wasn't good when I actually used one for recovery.

It's all good. I'm not good with math. Just my experience with them I guess. To each his own

Yup. Sure do. Works great. Especially for other tasks besides vehicle recovery. Removing logs from trails, etc. I don't have to worry about dragging it across the ground. It's there. I take care of it. And it works.

I'd have to go look. But I think the soft shackle I have is rated at 18k pounds. Insert one snatch block into the mix and you have now exceeded its capacity. I've seen one break during recovery, that's why I won't use one. If you like them. That's cool. I'm just saying I would not use one...

I use the soft shackle as a rear view mirror ornament. I wouldn't suggest using it for anything more then that, although my hammock line was a hair short one time, so I did use it to extend a little bit.. I will say I didn't sleep as well that night knowing my body was 3 ft off the ground being...

do you care if the clips are broken?

How much for the passenger airbag handle?

Yeah, sorry.. the lower cowl... yes.. i am familiar with the exploding part