Search results

delete delete please deal was too good to be true

A couple weeks ago I had a VERY weak battery in my truck, tried to start it and all I got was zapping noises from all over. I caught a whiff of Lucas smoke, but since we had a strong southern wind that day, I figured it was the trash burner in downtown. From that point forth, when my stereo...

I have been searching around and can't find shit for info. I am looking for part numbers, free length/coil/wire dia for the various D2 TD5 springs. From what I can see, RAVE only has the NAS/V8 coils listed. I would like to use the weight difference between my V8 and the TD5 mills to...

What is the best/quickest way of getting in contact with our forum ownership? PM (Axel, ??), E-mails listed on contact page, smoke signal?

Yay! I pulled my upper plenum off to hunt down my slow coolant leak out of the rear of the engine. Turns out to be the rear end of the passenger side head gasket. No big shocker there. During the removal of all the crap on top of the motor, I managed to break one of the very brittle SAI...

...

00 D2 ACE, TCS, ABS, no warning lights illuminated after startup light tests. Looked in RAVE and couldnt find any info. We got a layer of the slick stuff last night, so I went for a drive today. I couldn't get the ABS or TCS to engage, then on e cloverleaf onto the freeway the truck was...

Sold the D1, so selling the parts I can't use on the D2. Rovertym caster correcting radius arms for 3" lift with poly bushings - SOLD Salisbury rear axle from Defender 110 HiCap, needs hard brake hoses Front axle from the same D-110, swivel balls are perfect, needs some seals, has rovertym...

Beesearching all morning without finding a clear answer, so I hope you all can help. I have some RTE parts sitting in the garage and would like to know if any is actually useable on my 00 d2. - 3" caster correcting front radius arms - adjustable panhard arm - adjustable front shock mounts -...

I have 2.5% courtesy of the PO, and already removed the front side windows because I couldn't see shit at night... and it's illegal here. Before I go pulling down the rest of the tint, I was curious about the chances of finding OEM tinting on the rear windows. Was the '00 SE7 shipped from the...

I am looking for all the D1 parts needed to do the conversion on my '00 D2, or the linkage set from an 04.

I have searched but no luck to finding an answer. '97 D1, V8 Auto, 211,111.2 (as of last night :)) I pulled the codes for the ABS using the jumper method, and got 2-6, brake switch or fuze in underhood #5 (30a). Replaced the switch, and verified the fuze was good, same with the other two ABS...

I am selling a pair of axles from an '84 Defender 110 HiCap. Purchased for my disco, but I am going another route and the extra strength is not needed anymore. Coil sprung axle without a bunch of rust and crap, ready to swap into coil Defenders, RRC, and D1 (maybe more, but I am not sure) You...

SELS vs. AELS o2 Sensor Differences I find it irritating when I find a thread regarding what I want to know, there is no answer/ideas posted. So, I have edited this thread and will attempt to end this cycle a bit, and present my findings as they happen. Issue: All websites list the split...

It seems as though my ZF is on it's way out the door (blackening fluid, and tons of material on the drain plug magnet). I am looking to get an idea on prices for a complete 5spd swap that will bolt into the truck using the existing t-case shipped to 55420.

I was just given an ARB bumper off a friend's RRC in exchange for a trans filter swap. The bumper has a slight twist on the passenger side that should be easily removed by a frame shop. The frame shop in question has requested the bumper be installed for the work to be done. I am planning on...

97 SE7 No CEL, or other warning lights beyond ABS I was having some issues with the disco on the freeway. About 20min into a drive at 55-65mph the engine would start to buck, bogging when throttle is pushed and backfire when throttle is released. When I dropped to surface streets she ran...

I just picked up some parts from an acquaintance for my budget disco project. On the pallet is a Salisbury rear axle with the following casting number. I am going to order a Trutrac for the diff, but want to make sure I get the right PN.

Just picked up this little toy to build my next expo truck on. She needs some work, but runs like a champ and is 100% stock. '97 SE7 $500 I am needing a new windscreen, took a hell of a rock on my way back from picking it up. The windscreen in the truck now is a replacement. When plodding...