Search results

I installed this upgraded version a few years ago and so far so good. Not cheap but if it lasts it will be money well spent. https://www.sportscarcentre.ca/MGM000010K

I replaced mine last year. GKN part no. 4E0-498-203. I ordered through Pelican Parts using their number 4E0-498-203-M60 for $20.75.

More pictures

I have been planning on doing this for a few years and finally got around to it thanks in part to this thread. The rear door was already damaged prior to my ownership and was difficult to close. The tire is 315/75R16 which is obviously way too heavy to be mounted to the door. I looked into all...

Did everyone use the overlapping or non-overlapping style?

I did check the ground behind the left headlight and found it was bad. I repaired it and the 4022 fault went away with no codes for a short time. Now I am getting this 4012 fault and really cannot find any information on the cause and how to fix it.

I had been free of the Three Amigos for a little while but they have re-appeared and the code is: Fault 4012 Pump Failure 1 (High level at X2 Pin 8 without pump actuation) Any thoughts on a cause and how to fix? Background: I previously had fault code 4022 Earth not connected to ground. The...

Fault 4022 Reference earth not connected to the ground I just finished replacing both front hubs complete with ABS sensors. The two rear hubs and sensors have also been replaced. I have the three amigos plus the brake light on. The only remaining fault according to my Hawkeye scanner is: Fault...

The time has come to replace my wheel hub assemblies on my 04 D2. The Land Rover manual says to use STC 50554 sealant on the driveshaft splines on reassembly. Apparently an equivalent of this sealant is Loctite 648 retaining compound. My concern is removing the hubs in the future. It sounds like...