Search results

Just took it out for the test around the block. As soon as the engine warmed up, light started flickering below 1000rpm. I can bump the throttle and the light goes out. Shut her down for now until I can strap a pressure gauge on.

I inspected the gears yesterday, the outer gear was installed backwards. While in there, I serviced the oil pressure relief valve, which definitely needed a new o ring

I?m starting to think I may have installed the oil pump gears backwards. I?m going to tear down this week and will report back with my findings

I haven?t swapped my viscous fan clutch. It was pretty dirty when I did my timing cover gasket and oil pump gears. I cleaned it with a rag, toothbrush and carb cleaner. I didn?t inspect the oil pressure relief valve when I did the pump. Is that something that can be serviced without having to...

No greasy mess. I?m showing no signs of leaks

Spoke too soon. This morning after warm up. I lost oil pressure once again. What could be causing pressure to drop after warm up?

I filled her up and have restored oil pressure.

Update. Pulled the pan today and I guess I might have been a bit overzealous in my application of RTV on the reinstall. Lots of rtv bits in the bottom of the pan. Cleaned out the pickup and pan. Installed new gaskets in both. Will test tommorow and crossing my fingers that this was the problem

I did when I did the oil pump. This weekend I plan on dropping the sump again.

1995 D1 with 3.9 210k miles Just did the timing cover gasket and oil pump. Initial start up oil pump went out and the oil sensor started to leak and then I lost pressure. I replaced the sensor last week and changed the oil from 10w30 to Rotella 15w40. With this my oil light went out. I had good...

Hello everyone! I have a 95 Discovery and I have noticed that the rear door check strap is missing. Will a check strap off a Disco 2 fit a Disco 1?

atlantic british might be a good source of supply