Search results

I have a leaking rear pinion seal on my 1991 Range Rover. Can I change this with the differental in the truck? Or do I need to put it on the work bench? Also The heater core is leaking. I have changed one on my 1994 Discovery and swore that I would sell it before I would do that again.:banghead...

Don't know if this old news, but I did a search and did not see this anywhere. I got an Imperial fan clutch from Advance Auto Parts today for my 91 Range Rover. The part number is 215053. The cost was $65.94. I put it on today and my temp gauge stayed between 180 and 195 for about an hour while...

I just put in a temp, oil, and voltage guages on my 1991 Classic. For the temp gauge I cut one of the heater hoses and put in a tee and mounted the probe in there. I am finding that the temp will run 190 to 200 while driving and can go up to 220-230 while on the trail. I left the electrical Land...

Picked up an 89 Rangie the other day. I took a U-Haul car dolly to pick it up, cause it is not running. When I showed-up, I told the guy I was going to take off the rear drive shaft roll it up on the dolly and be on my way. He said the rear shaft is already off because he had moved it to his...

There was a discussion on D-Web a while back about changing the air bags after 10 years. Well my son proved today that they still work after 13 years. 1994 Discovery rear-ended a Dodge Neon. Tore-up the Neon real bad. We had the front bumper off the Disco and it banged up the front pretty good...

I am missing a couple of the exhaust studs where the exhaust manifold attaches to the catalytic converter. I ordered new ones but the won't tighten-up. I checked the part numbers from a couple of sources and appear to have the correct parts. Is it common for these holes to get stripped? If so...

I replaced my transfer-case mounts recently and had a hard time getting them out. I had to support the case with a jack and remove the metal mounts on the frame to get them out. After everything was replaced I had a new vibration when driving. Figured that I had gotten the case mis-alinged...

I need a tie rod/track rod for a 1991 Range Rover. Not the drag link in front, but the one behind the diff. Thanks Charles Allen

I need the glass for the passenger side for a 1994 Discovery, or maybe the whole mirror assy if cheap enough. Charles Allen

I am putting a Detroit in the rear of my 1991 Range Rover. I am going with a 24 spline Detroit and heavy duty axle's in the old 10 spline housing.I have searched and am still confused about what carrier bearings to use. I think the Timken set 47 or the equivalent bearings #LM102910 and #LM102949...

Are the front and rear differentials interchangeable? Can I take a standard open rear differential and use it in the front? Or just the opposite? Thanks Charles

The center pin broke on both of my diffs in my 1991 Rangie. :ack: I am wanting to put TrueTrac's front and rear and upgrade to 24 spline axle's. The ring and pinion look good in the rear, but on the front ring gear the teeth are chipped a little on the far outside edge. I hope you can get an...

http://www.i-am-bored.com/bored_link.cfm?link_id=21337 :ack:

I am changing both tomorrow on my 1991 Range Rover. I have changed the motor mounts on my Discovery and Rangie before, but never the transmission mounts. Anyone got any good advise? Charles

I am wondering if mine is bad. With the truck running I can only push the brake peddle twice, the the pump comes on for a few seconds. I seem to remember reading somewhere that you should get 10 to 12 pumps. Can these things be rebuilt by someone? I have a 1991 Range Rover with 138000 miles...

I have a 1991 Range Rover that the AC is not working. The compressor does not come on. I can jump out the pressure switches on the dryer and the compressor will kick in but no cold air and I dont see anything in the site glass. The system has a sticker that says that it has been converted to...

Got some shakes in the front end of my 1991. Not quite the death wobble but getting aggravating. I checked the swivel pin preload and it was good. I have switched the front and rear tires and wheels and got no change. I tightened up the screw on the steering box to take the play out. Mabey a...

I picked up a 1991 Range Rover over the holidays. It has a OME medium duty lift. I have a set of BF Goodrich 235/85/16 tires on my Discovery that I am thinking about puting on the Rangie Rover when I go off road. I have done some reading on Rangerovers.net and as usual there are several opinions...

Its been a rough month. Heater Core, Water Pump, Rear End. Santa won't answer the phone when he sees my number in the caller ID. Charles :(

Next ime I have a heater core go bad I think I will just sell the beast and buy another. Charles :(