Search results

Hello, I know I could probobly search around and figure this out, but I've been out of the loop for a while and would like some input to get me started on the research. Looking to purchase a 2003 Disco SE, and want to lift it. I had a 1997 Disco that I lifted with OME and liked it a lot...

Im getting a couple of seconds of run on after turning my ignition off, any remidies? Note: My truck has been at a stationary idle more than usual this winter as a result of the -40 degree weather, I know its not great on the truck but somewhat not optional. My guess is excess carbon being...

Please tell if I'am retarded or just habe the LR bug. Currently garaged: 1997 Disco, 2003 Freelander Anyways, Looking at a 2000 4.6 HSE with 54K miles on it, no obvious signs of neglect or problems. Only thing i could tell was Climate control led were not all working, leaks a little oil (...

Ok need a little help, weather is in the -30's and My disco is stuck.... Key wont turn have searched the site and concluded that this is somewhat normal : ) But along with not turning the key buzzer when door open is not coming on.. My plan was to remove lock cylinder tommorow so i can get to...

Recently bought a 2003 freelander, Day after i bought it right rear window broke, water ingressing rear stowage compartment and rear window not coming up unless I use key to lift it from outside. Very angry and thinking how typical, I headed to the dealership with intentions of using the lemon...

Looking to replace the head gaskets on my 97 D1, never done this before, but I think I should have no problem doing it, if I could get some pointers, how to's, and required things for job.. Thanks much

Ok after viewing some threads on the priming and order of oil change, I am a little worried or confused. How critical is it to do the procedure, I have changed my oil twice sice I've had it and both times I drain oil and drop filter and replace filter then fill with oil, Is this wrong, If it...

Well finished, OME 751,762 BF Goodrich MT 235/85R16 Very pleased with end result, no trimming or anything yet, will adjust the steering stops though.

Ok just recieved box one of my lift Rear springs and shocks are coming tommorow however I did get the fronts(751) a day early I guess, and since I wasn't able to install only having the springs of course I had to take them out and just admire them, I notice there is an A and a B shock and one...

Well I finally ordered the Lift, 762, 751, and N45's for front, leaving rear shocks for now as they are still descent and trying to save a few $$. Also ordered BFG 235/85r16 MT's I did all this based on most concensus throughout the forum, I hope I did well. Anything I should be aware of...

Will the 235/85r16 fit fine on the oem wheels, as the tire is not quite as wide.. Im almost positive this is ok just wanted to check.. 1997 Disco I Thanks

Ok this was a wierd one but maybe worth looking into if yours is broke and you have no clue. Ok My cruise didn't work finally got around to fixing it took out the motor and it worked, disconnected the line from the Throttle diaphram and blew into it with the motor end plugged and noticed that...

Ok this june I'm going to be moving to alaska and I'll be driving up there to fairbanks from Portland OR 2300 Miles. I plan on towing a trailer with my 74 Land Cruiser on it. I'm wondering what to expect with that weight and a long drive?? Thanks

Ok gonna do my lift now.. Going with the OME 781/751 setup, and hopefully 235/85r16, Ok question time cuase getting ready to order... Do i need new shocks and steering stab, and is there anything else at All I would need to complete other than a Spring compressor??? Thanks In Advance

Anyone know if the toddco Headers are worth a damn??

I plan On lifting With OME here in near future. Was thinking of getting some 2 inch spacers for now and then doing about a 1 inch with the OME... Will i need to replace anything with just a spacer install( Shocks streering etc. ) or can I get away with stock until i put the OME on.. Thanks any...

Does a 97 Disco I has a transponder key???

I noticed this week when I do a quick feathering of the gas and then back off at first it seems to ping or knock, could this be my Octane?? It never seems to ping under load up hill or any thing.

Anyuone know what this symbol is in regards to wiring schematics??

WTF is up with these window regulators?? Had My disco about 2 months couple days after buying passenger rear went out, fixed it, week later passenger went out, fixed it, this morning drivers went out, and i think I here the drivcers rear ticking like a time bomb : ) :confused: