Installing headers and D1 and picked up a D2 90 deree knock sensor to use on the driver side. The hole on the D2 knock sensor is smaller than the bolt I would use to screw it to the block. Question is do I drill out the hole larger or do I have to make a special bolt or adaptor to install the D2...
Have as set of hedman header ready to install on 1998 Dico 1, already heated and bent. I already removed, broke off the driver knock sensor while dry fitting the headers. In other post they refer to using a 90 degree knock sensor, Are they referring to the Disco 2 sensors that use a bolt?
Thanks
Changing the swivel balls on a 1998 disco 1. Putting on swivel balls that are redrilled for new lift. Have only changed out one side so far. Have a few questions before I start on the other side.
Will it make a different in preload if the redrilled swivel balls are crome colored and the old ones...
Have four 235/85/16 BST radial M/T tires. Almost new, about 1000 miles on them. Prefer pickup, but will ship, have no idea what shipping is on tires.
$250 plus shipping
Rovertym 2" springs and 2" OME shocks, front and rear, 8 months old. In perfect shape springs have no rust. Shocks have some scratches from install. Loc in 91711 weight is 100lbs
$440+ shipping
Removed the front driveshaft (going to have a new DC one built)and my D1 no longer moves. The rear won't engage. Thought I could still drive it until the new drive shaft was built. Appears the drive line requires both front and rear drive shafts to run, is this correct.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.