Search results

D1 exterior drivers door handle, D1 sunvisor clips, front d1 tan seat covers if in decent condition. Let me know if he has any of it. Thanks!

Thanks will be sending paypal to drill bit later this evening.

Im looking for a straight tie rod to replace the one i have, which looks like its doing the wave. Its for 95 D1. Also need a passenger side window regulator for the same truck. thanks, Will Also I don't care about tie rod ends, i have new ones waiting to go in it.

One of the tie rod ends on my drag link is bad. It is the tie rod end that is located on the knuckle end, not the steering box end. I know one tie rod has a left hand thread, so I just wanted to figure out which thread I should order before I get the wrong one. Thanks Will

Mine also locks up at 50. im doing about 1800or so at 55, and close to 2500 rpm at 73mph range. im running 32" tires too though and stock gearing

I just went and measured mine and it appeared to be a 2 13/16 diameter pulley. I measured this across the front of the pulley, hope this helps.

Its my truck, it has 245/75/r16, 3" rte and 2" body lift. Im moving up to 285's and ditching the body lift soon though.

No worries I ended up picking one up off one of the pick-n-pull discoverys there. Thanks though.

If its in good shape without any gouges I will take it.

Im looking for a 1995 D1 alloy rim, as well as a complete set of tires in the 33-35" range.

I am also replacing the dryer, sorry i forgot to say that. It has been out of freon for probably just over a month. It was a quick puncture leak. The bolt from the rear spring retainer rubbed a hole in it.

I had a hole in one of the metal a/c lines that went to the rear a/c. i took the line out and had the hole welded. I have all the tools to draw a vacuum on the system and recharge it, but im not sure if i need to add oil back into the system or if the old oil stayed in the compressor and can be...

Awesome job on the rack it looks really good. What size conduit did you use? I plan on building one myself. Any idea how heavy it is?

thanks, I may try the dealership and see if they have any of the support pieces first. if not i will send you a pm Zed. thanks, Will

Im looking for two manual front seats out of a D1 in decent shape. The bottom support band broke in both of mine. thanks, Will

bump..still available

I have a set from my D1. How about $60?

I have a new in the box brake booster for a D1. Its a TRW I believe. I'm asking $285.00 plus shipping. thanks, Will

95disco87xj and crown14 i sent you a pm

I liked them they were a good way to get the clearance I needed to run the larger tires. They were easy to install, they only took me one day to put in. I will check on shipping and get back to you. thanks, Will