Search results

Thank you. That's what I was looking for.

I want to run some thicker cable from the battery of the LR3 to the rear left inside panel. This is 10 AWG cable, need to power the big compressor which requires up to 40A. The question is: along where is the best way to run it? Inside middle, under the carpet, or along the sides (inside) or...

My ABS Amigo reset tool came today. Very easy to use and it did the job of reseting the codes and lights. Glad I spent that money.

I had the same problem with 8mm Magnecores which I bought from 4x4ag.com. The two short cables were really short and just made it, but touching the valve covers. The guy at 4x4ag was initially helpful and said that he contacted Magnecore. That was that, never heard from them again.

I tried it - one quart of ATF with one full tank - the D2 is still running fine. Didn't see any loss in fuel consumption.

Here's a diagram which I sketched last year.

Found this DII Brush Bar which needs hardware and plastic that covers hardware. Can anyone tell if this will fit a 2001 DII or is it specifically for the 2003-2004 models ? Thanks.

and maybe a bit less too.

leaking like this (in the picture)? There is a technical service bulletin in the forum with the topic "Series 2 Preheater gasket Campaign" with good instructions.