Search results

  1. T

    Replacing heater core....:(

    I checked this site a couple of times over the past week or two and always appeared to be down or I would have asked some questions before I got so far into this... I slid the heater core out without removing the whole blower/heater/air condition box (I forget the name, yes I did remove the...
  2. T

    Parting 94 D1

    How much for the shocks?
  3. T

    Parting out Trucks

    Sorry I mean A/C condersor fan/s
  4. T

    Parting out Trucks

    Blower motor for 98 disco, 'nice' tan front floor mats?
  5. T

    D1 PS rear door outer molding black...

    Good condition. Mine started to pull up a little then finally bent and mostly pulled off when it hit the front door when I opened the rear one. Thanks
  6. T

    Parting out 2 96 D1's

    I need passenger side, rear, exterior door molding. Black, good condition. Also what about fog lights? Thanks
  7. T

    Need quick easy help....please

    Thank you so much, I'd connected one prior to writing this post and was going to do it incorrectly.
  8. T

    Need quick easy help....please

    Thank you SO much, by outside you mean the drivers side fitting correct?
  9. T

    Need quick easy help....please

    I'm trying to finish changing my valve cover gaskets and made the fatal mistake of going to fast and not marking things. I need to know, on the intake plenium, there are two coolant hoses. I dont remember which one goes where. Does the long one go to the passenger side port, or drivers side...
  10. T

    98 Disco key fob, visor clip

    Paul thanks for the visor clip. Darren thanks for the link. I'll go with them, it's nice to know you went through them and are happy with the product. Would you by chance have the programming instructions? I did a search here for a few minutes yesterday and didn't find what I needed but I...
  11. T

    98 Disco key fob, visor clip

    Paul, PM sent Darren Thanks
  12. T

    98 Disco key fob, visor clip

    Paul, Sent it just now, thanks. Now how about the key fob? Anyone?
  13. T

    98 Disco key fob, visor clip

    Need key fob for 98 disco. Also need visor clip for same year tan. Tanks
  14. T

    Thanks in advance for the assistance...

    I dont even want to talk about my experience at the dealership. Amazing how they can screw up such a little thing and charge for it. I just want to be over it and not even get aggrivated explaining it which is why I have not updated this thread since Saturday. It apparently was the inertia...
  15. T

    Independent shop in Murfreesboro TN area?

    I'd like to know also. Definately not the dealership. I had such a time with them when I picked up mine this past Saturday that I dont even want to get into it. I need to update my thread. (One of the Nelsons did give me his card told me to call him if I ever need to bring it in again)...
  16. T

    Thanks in advance for the assistance...

    Well just take it to the dealership so they can charge you $25 for the switch $90 for diagnostic, $45 (1/2 hour) to replace the switch, and $90 for "fixing the wire that goes from the switch to the fuel pump". Then you could ask them what wire, they will say "I dont know exactly", then you...
  17. T

    Thanks in advance for the assistance...

    Passenger side engine bay firewall. Has a rubber top facing the sky about the size of a quarter. I was just searching some other threads about it. It appears that there is a way to bypass it or just disconnect but I'm not sure how yet. Some say they just push down on it (if you find it you'll...
  18. T

    Thanks in advance for the assistance...

    I guess when I say "checked" the switch I was just referring to it not being popped up. Is a short/malfunction in the inertia switch relatively common?
  19. T

    Fuel Pump - Issue???

    Check out my post from today titled 'Thanks in advance for the advice....' Good luck