Search results

Need receiver adapter for LR3/RRS.

I now have this tool from RSW, thought I'd give it a shot on my RRS, since they are basically the same vehicle. It looks at literally every system on the vehicle that a regular ODBII couldn't touch. Now no need to go to dealer to have them hook it up and charge for it. Worked great for me...

uhhh

I've read some stuff too about poly bushings wearing out a lot say to grease them which I did very well. That said they were cheap and easy to replace. And believe it or not I almost forgot to mark the bolts but just as I was getting my tools I saw a mark on them from either factory or a...

Got it done....first side took 3.5 hours. Most of that time was spent playing around with the bushing looking at ways to get it out. Finally got my drill and went around with the drill cleaning out the bad rubber, then worked the center piece out. Then used a sawzall and cut enough to where I...

It will be interesting to see how I do this. Not sure may have to bounce it off a buddy that owns a shop look at tools he has. Bushing should be here this week....if they turn out to be crap at least they'll slide out since they don't have to be pressed in.

Well I have a press. Just ordered the poly bushings, will remove completely and press the old ones out. Can't be that hard right? Edit: Will just pull the entire lower control arm out.

About to attempt this on a RRS has anyone dones this successfully w/o taking out the entire control arm or is this necessary, can't see it good right now in the dark but looks like a pressed in unit from what I'm looking at on Roverparts.com.

Was considering one not near that nice in FL panhandle...same money. I wished you were closer.

Standard NGKs too....last set I put in right at 50K...I'm at 136K now.

Not sure I'd do this....might end up with hot spots on the engine when running only a minute w/o coolant. I'd just dump all that would come out with engine cold/warmish....re-fill with distilled water and run long enough for t-stat to open and circulate some. Then let it cool back down dump...

Hope you disconnected the battery right away?

Either that or it just really wants more and more gas!

I have this same bumper on my 03. I didn't like the bull bar portion so I cut that part off. The picture is of the truck before I cut bull bar portion off just to show it does fit all the D2s no problem. http://www.discoweb.org/forums/image.php?u=6962&dateline=1225679459&type=profile

Run some marvel mystery oil in it to clean things up. I had a knock on mine and I'm guessing was a clogged lifter...anyway knock has been gone since running the MMO. Run a half bottle of it twice a year now and have no weird knocks.

x2 saw on the factory one being available from Lucky8. I am also running the mod on the gulf coast here in Florida with a 180 and a new radiator. I idle at 188 and run around 197 cruising at speed, around 200 pulling the boat if it's really hot outside. I have noticed that my temps at idle...

x2

leak

Driveshaft.

How long till you want to part the X5? I need a few trim pieces...