Search results

My thanks to K-rover for the link: I finally got it straightened out, and once again have the Manual. :)

Thank you. I must be such a dunce. I clicked the link, did the thing, and.....there's a new toolbar and no indication at all where to look for the stuff I want. Bunch of options that don't lead me to *anything*. I imagine I'm doing something wrong.... iMac/OSX

Just acquired my third Disco II. The previous one got tagged by a guard rail, in a snowstorm, and went to the salvage yard. I looked for over a year and couldn't find a suitable replacement, but last week, I jumped back in the deep end with a nicely-modded 2000 that came available. My problem is...

Trey :: 2000 Land Rover Discovery II (2015-05-04 22:49:38)

Have an opportunity to acquire an `01 D2 in overall very clean condition, for a very good price. Truck has two problems, one of which I can repair easily (throttle body heater plate leak), one of which may or may not be a deal-breaker. At the rear of the engine, there is one (or maybe more than...

PMed you about the chains. GSMullins

My experience with ACE has been positive: on my 3" lifted unit, body lean is minimal on the road, yet off road performance (axle compliance) is still good. Go for a unit with verifiable service history. If over 60K, head gaskets may be an issue, so any truck with higher mileage that has had...

I expect to be there. Thanks for putting this up. In. :victory: mully

I just had this exact experience, so its fresh in my mind. Remove the ash tray Find the two tabs on the plastic fascia directly below the clock; while pulling them down, press the clock out from behind Turn the clock over; find the round, black bulb holder on the bottom and use a small...

That's a good article - thanks for sharing. Daniel Stern's site has a ton of good info! GSM

It was the 'upper' joint. Mine had head work done just before I bought it, and I suspect the loose clamp was oversight from that job. Try splitting the weights - half the amount on inner, half on outer. Or you could go with stick-ons dead center on the inside of the rim, but check for...

A similar problem on my 00 was a dynamic wheel balance problem. Whatever total balance weight you have on the wheel should be split inner and outer; if not, the weight tries to turn the wheel in & out as it passes through the steering centerline on each revoluton. I also found a steering column...

I want a Safety Designs roof rack for a D2, in good shape, within driving distance of Orange County, CA, price under $750. I'll pay $50 to the 'bird dog' who brokers the connection between me and the rack I ultimately buy. PM me, please. Mully

Here's a pic of them: Anybody? Bueller? :cool: mully

Thanks to Roverdude, I was able to snag a nice set of four 16" Prolines for off-road wheels for my `00 Disco project; now I need a spare. Anybody got one? Prefer SoCal local, but will entertain all offers. Thanks in advance! GSMullins

PM me, Ondfly. I'm also SoCal, and depending on what you got, may be interested. mully

If they're unsold, I'll take them. I'm also OC and can pick up Monday or Tuesday evening. GSMullins@macDOTcom

Hello all. New to DiscoWeb, but not to Rovers. Just acquired my second DII after a two-year hiatus and would like to pick up spare set of 16" OEM wheels in SoCal area (I'm in south Orange County). If you have a set (prefer 5), email or PM me with particulars. GSMullins aka Tom

Sent you an e-mail message. GSMullins