Hi all
1996 discovery
I just finished putting on a lift 3 inch with rovertym arms front and rear. Dnew f and r driveshaft too. As I accelerate it is fine but as I ket off of the gas it gives a loud gear noise. Any ideas?
Also it wont say running at idle. Any help is appreciated
Hi all
I am working on removing the head to change the gasketS and I have 3 bolts I can't get out. I have sprayer them and used an impact gun. Any ideas on how to get them out?
Thank you
Hi on my 96 disci I am changing the head gaskets and was wondering it I have to take the actual valves out or can I take off the whole head with the valves intact?
Thanks
Ok I changed the crank position sensor and it still starts for a second and dies it stays running a tiny bit longer if I give it gas I cant 5hear the fuel pump running I took it out and cleaned it up thinking it might be the filter on the bottom of the oump but still the same problems I also...
On my 2000 d2 I am going to change the head gaskets should I spend the fortune and buy their head bolts or can I find them at my local nut and bolt store
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.