Search results

The front driver's side turn signal housing fell off my daughter's 2001 RR. Just the plug is left on the car. Need replacement. Randall Smith 100 Woodwinds Industrial Court Cary NC 27511-6240 919-469-3332 plastictooling@gmail.com

My daughter has a 2001 RR at USC in Columbia; I am 250 miles away. The ABS pump need to be replaced. Anyone know a friendly tech near the school?? Randall

I have 2 vehicles that are running the 100amp alternator like was on the 1995 RRC. Neither vehicle uses very much electrical power, but they still fail more often then you would think. Also they are not Lucas, so you cannot blame it on George. The last one failed suddenly. Started the engine...

I need to order yet another MAF for a 2001RR today. Part# MKH100800 which I recall is the same one used on 2003/4 Bosche Discoveries. You can buy a bushel of MAFs off of Ebay for the same price as one "genuine" MAF. I did find a Bosche MAF on Ebay for $169, but that is still two or three time...

Last month my BeCM got a little wet after rain water leaked in from the sunroof, dripped onto the seat, then the computer. Some of the electrical problems created that day just will not go away. So I will have to try another BeCM. 2001 Range Rover. Part# on computer is YWC112210 Randall Smith...

I am starting this thread to tell you about most of the systems which are not on my 1992 RRC. The purpose of not having these systems is to simplify the vehicle, reduce the weight, free up space and electrical circuits, reduce the time and cost of maintenance and repairs, etc. This truck is...

Almost every component from my 2001 RR air suspension system available. Also have EAS reseting tool which has saved me a trip to the shop half the time the system threw up. Air springs are ~2 years old. Compressor works extremely well. Let me know what you need or want for spare parts. Can...

A while back there were some postings regarding a problem with some of the later Rover v8 engines. As I recall, the alignment pins of the front cover was not correct. This led to the destruction of the oil pump gears?? Was the problem due to the block being drilled wrong, or to the front cover...

Have a new starter motor heat shield and mounting bracket to fit RRC or Discovery1. part#s ERC5875 and ERR117. Good luck finding new elsewhere. $29 includes shipping within USA. Paypal to sales@plastictoolingcorp.com or send cc# and address to same email. Randall Smith

Have a set of new Discovery2 or RR(199-2002 Bosch) ignition wires. These are Rover/Leoni cables, not aftermarket. $39 includes shipping within USA. Paypal to sales@plastictoolingcorp.com or send cc# and address to same email. Randall Smith

Have a set of gray RRC or Discovery cup holders. They are new with all fasteners and instructions, but there is no box. $39 includes shipping within USA. Paypal to sales@plastictoolingcorp.com or send cc# and address to same email. Randall Smith

Three years ago I purchased a 2001RR 4.6HSE with ~120k on the clock. Over the course of two years I acquired every part that could be found that goes under the hood for a total engine bay overhaul. Almost every part is new, or remanufactured or refurbished by me. Everything was assembled and...

Can you run the engine with no oil cooler?? Answer is yes. Decided to try removing the oil cooler lines from one of my RV8s with the intermediate type front cover. I just used those white plastic plugs that are on the new front covers to plug the holes. The plastic plugs even have an o-ring on...

Have a Tom Woods front drive shaft made to fit Range Rover Classics which have the Borg Warner tarnsfer case. It is 26.5" long when fully compressed. This is longer than the front drive shafts used on the early RR and the DiscI which have the manual locking transfer cases. But if you have a big...

All of these parts are brand NEW old stock Range Rover Classic parts. Let me know if you are interested in anything. Don't be shy. Good luck finding these parts elsewhere...especially at liquidation prices. Can accept any form of payment. BTR333 & BTR2752 tool kit bag(no tools) MXC1196LCQ...

Have a Tom Woods front drive shaft to fit Range Rover Classics which have the Borg Warner tarnsfer case. This is longer than the front drive shafts used on the early RR and the DiscI which have the manual locking transfer cases. This unit only has ~10k miles on it and was greased often...

1992 RRC fuel gage reads less than 3/4 when full. According to the owners manual the tank holds 21+ gallons and the idiot light comes on with 4 gallons left. That part checks out but the gage reads low which is annoying. There is suprisingly little info in the ETM for the fuel gage. I can only...

How can you tell by examining a front cover if it is for the Bosch(1999 & up) Range Rover?? Is there any single feature or marking which distinquishes it as being different from the other non-distributor type front covers?? Trying to finish an engine that I am building to drop in my 2001RR. But...

I wanted to know if you can use heater core part# STC250 in a 1992 RRC?? The actual part# appears to be RTC6593, but some vendors are showing the other part# which was used in the final years of the classic. Do not want to go to the trouble of pulling the heater core out only to find that...

Have a pair of non-ABS type swivel ball housings off of a RRC. These housings have been totally stripped down and cleaned in a solvent bath. All the various fasteners and other parts which are attached to housings have also been stripped and are included. All you really need is some new gaskets...