Search results

Looking for a DII lower coolant hose... must have the plastic doohickey circled in red. Planning on doing the thermostat swap and need the plastic tee thingy. Shipped to 80134. Thanks!

Just bought an engine taken out of a good running '97 Disco with 97k miles. Came with all accessories, and all I needed was the short block. So I'm selling: Alternator (paint marked, looks like a newer part) $80 + shipping PS pump $35 + shipping Starter $80 + shipping A/C Compressor $100 +...

Just bought a '00 Disco with a head gasket leak/possible slipped liner. The prior owner had the headgaskets replaced in Feb 2007; now combustion gases are back in the coolant, so I am preparing for the worst. Do you have to re-sleeve all the cylinders, or would it suffice to re-sleeve only the...

Any reccommendations for a machine shop in the Denver, Colorado area? I'm about to buy a '00 Discovery with a slipped liner. I'm looking for a shop that will re-sleeve the slipped cylinder and pin it, and pin the other 7 sleeves while they are at it. Thanks!:patriot:

I was using electrical contact cleaner on the 4 low voltage leads to my coil, and I think I may have mixed up the connections when I re-connected them. I've looked through the FSM and can't seem to find a discussion of what wires go where. One of the wires, a black one, goes to what appears to...

My '93 4.2 LWB has been tearing up the snow here in Denver (finally got my heater blower working-- thanks PT and everyone who helped on that), but the other day I went to start it up, and it turned over but struggled and never started up. First I though my battery was weak so I took it home and...

My heater blower isn't working, its been that way since I bought the truck. I was lucky enough to find a '92 RRC at Pull-n-Save yesterday and I pulled the heater box. There is an electrical cable to the blower motor that exits the upper driver's side of the heater box, then runs across the...

Getting rid of some spare parts I've accumulated: RRC Throttle Position Sensor (from 1992 3.9l RRC) $50 shipped RRC Stepper Motor (from 1992 3.9l RRC) $25 shipped RRC Driver Side rear caliper loaded with pads NEW in box $50 shipped I also have a TPS from I believe a '96 Disco that I...

This 1993 Range Rover Long Wheel Base is the County model. It has 155k miles, and runs exceptionally well, with a new water pump, belts, tps sensor, rear caliper and pads. No fluids leak, not even the power steering pump or swivel balls. Interior leather is in fine shape, sunroof and factory...

Need to get these out of my Garage: 1) Professionally remanufactured Lockheed Drivers' side rear caliper, loaded with new hardware, still in box, $50 shipped. 2) Pair of used rear Lockheed calipers with pads from a '89 RRC, in good shape, pads have plenty of life, $50 shipped. 3) Rear lap...

Bought this '96 Disco Throttle Position Sensor with hopes it would fit in my RRC-- it didn't. $25 shipped. Thanks!

Hi, I need a throttle position sensor for a '93 RRC LWB with the 4.2, shipped to 80134. I understand that the TPS is interchangeable with the one in 94-95 Discos, and RRC's from 1991 to 1994... Thanks!!

Hi, I'm looking for an upper radiator hose for a 4.2L 1993 RRC LWB-- the one with the coolant temp sensor built into the hose, shipped to 80134. Thanks!

Looking for rear seat belts for my 1993 RRC LWB-- they got smashed when the seats were folded forward and smashed back. Don't need the shoulder belts, they are fine. Shipped to 80134. Thanks! *Bought these from Cambo--Thanks!*

I'm moving, cleaning out my garage and selling a bunch of parts from my RRC 1993 LWB. I'm located in Parker, Colorado. Call me at 720-250-7996 or shoot me an email if interested. I have more pictures, will email if asked. 1) LARGE 48" by 78" Roof/Cargo Rack-- $150 SOLD 2) Running Boards-- nice...