series 1 hybrid outriggers/body mounts

[cdansan]

I need dimensions and pictures of the mounts / outriggers to fab my own.
i need to fab all the mounts.
my project has none left to start from.
i would like to include sliders like the one Gordo has on his project.
you can mail pictures directly to me if it is easier, let me know and i will send my address to you.

Thanks, Dan

 

[Gordo]

Dan did you get the photos I sent over yesterday???

 

[cdansan]

Yes I did. thanks very much.
it looks lik ethe is some body lift incorporated into the mounts?
how large are your tires?
Dan

 

[Gordo]

Yeah, you have to lift the body some to get the tub over the hump in the rear of a RRC or D1 chassis. Dont forget the range rover axles are much wider so lifting the body up is a good thing. I used D90 flares in my first build. Check out the link I sent you for how I did that with plywood templates. Obviously I cut the shit out of this one! The tires are 37 x 13 Boggers. The rear axles are Maxi Drive, not sure about the front yet. Luckily mud is fairly forgiving... Gordo

 

[cdansan]

i am going to use th 88" RRC chassis i have for now.
if i decide i like 100" better i will either extend the body or chop it like yours
not sure about flares yet, need to find the body parts first to start mocking it up.

 

[leafsprung]

all the dimensions are in the series one workshop manual. There are PDFs online