| Author |
Message |
    
Jeremy Katka (Jkatka)
| | Posted on Wednesday, February 20, 2002 - 08:34 pm: | 
|
Hey all,
I just got my set of JATE rings and would like to install them. How would one get the front airdam off? I also know that I have seen some posts about the type of bolt to use though I can not find it now, Any recommendations? I have seen lots of picts of JATEs on D-90's but not on Discos.
Thanks
Jeremy Katka |
Koby (Koby)
| | Posted on Thursday, February 21, 2002 - 04:21 am: |
|
Bump to the top. I'm interested in this question too.
Ho??? |
Jeremy Katka (Jkatka)
| | Posted on Thursday, February 21, 2002 - 01:34 pm: |
|
I found this it looks like we might have to trim the bumper/airdam. http://www.expeditionexchange.com/jate/DCP_2436.jpg. Koby do you have an idea of a good bolt for use through the front horn.
Jeremy K |
Ho Chung (Ho)
| | Posted on Thursday, February 21, 2002 - 01:47 pm: |
|
for disco1, you can just undo a couple screws and nuts, and air dam comes off easily. |
Hank Shank (Disco_Tex)
| | Posted on Thursday, February 21, 2002 - 02:53 pm: |
|
On my D1 I removed my factory fog lights/mounts, took out all of the screws holding the front air dam to the bumper and end caps, then trimmed my end caps. It took about 45 minutes. |
|
Closed: New threads not accepted on this page