| Author |
Message |
    
jnalley
| | Posted on Wednesday, May 22, 2002 - 11:06 pm: | 
|
anyone have info on replacing head gaskets, such as torque specifications, should heads be milled down when replacing with composite gasket, or any other info that might be helpful. |
Ron
| | Posted on Thursday, May 23, 2002 - 12:16 am: |
|
Check the heads with a strait edge, if needed skim. do a valve job at the least (clean and lap valves).
Metal gasket is 65-70 on the inner two rows and 45 on the outer (some say even less)
Composite is 15 and then two 90 degree turns
Ron |
|
Closed: New threads not accepted on this page