| Author |
Message |
    
Patrick Cox (Ncroverguy)
| | Posted on Monday, June 03, 2002 - 02:06 pm: | 
|
I am about to install a full system in my 98 discovery with a pretty big amp. I was wondering if anyone could recommend a good existing location to run the power cable through the firewall to the battery. If there isn't one, where can I drill one? |
Craig Kobayashi (Koby)
| | Posted on Monday, June 03, 2002 - 02:22 pm: |
|
Perhaps some of the Disco 1 guys can elaborate on this, but I ran my amp power cables in my Disco 2 through holes in the firewall that were sealed by a rubber grommet. I just had to punch a hole in the grommet and the cable ran through perfectly
The holes were located on both th left and right sides of the truck on the firewall. I ran mine through the hole on the passenger (right) side by taking out the glovebox |
David Dryden (David914)
| | Posted on Monday, June 03, 2002 - 02:28 pm: |
|
I couldn't find a real good existing place to run my power cable through (I didn't spend alot of time looking either), so I ended up drilling a hole on the passenger side right above where the large factory harness goes through. Just be sure to use a grommet! Good luck!
David |
|
Closed: New threads not accepted on this page