| Author |
Message |
    
Mike Talley
| | Posted on Friday, June 21, 2002 - 03:35 pm: | 
|
While I was under the truck installing the new bumper caps I noticed a white electrical plug. Is that a plug for the foglights. My 99 Disco 1 SD doesn't have foglights. But if it is pre-wired for them all I would have to do is replace the air dam to one with foglight holes right? Thanks.
Mike
-------------------------------------------------------------------------------- |
dburress
| | Posted on Friday, June 21, 2002 - 04:01 pm: |
|
Correct and add the interior switch along with the relay. |
Joe Cole
| | Posted on Friday, June 21, 2002 - 04:11 pm: |
|
If you need lights, I have two factory light pre-wired just plug in. Let me know if you are interested. |
Greg French
| | Posted on Friday, June 21, 2002 - 04:58 pm: |
|
I still don't know where to put the relay.
I have asked a few times, but don't really get it.
Maybe I'm just a retard, too. |
Mike Talley
| | Posted on Friday, June 21, 2002 - 05:40 pm: |
|
Joe,
How much are you asking? |
jim malone
| | Posted on Friday, June 21, 2002 - 05:42 pm: |
|
Here is how a buddy of mine did it on my 1999 D1:
cut small strip (1 cm x 10 cm x 3mm) of aluminum sheeting to act as mounting platform for relays
drilled evenly spaced holes in strip for mounting of relays
attach predrilled strip to prexisting screws found just above the collision switch located back left of engine compartment (as you face your rover)
Wish I could show you a picture, but no digital camera....I could call you and give a clearer explanation if you want...
As far os the fogs themselves, better to place them on brush bar (if you have one) rather than trying to fashion holes in the damn dam (which is likely to just get bashed off in time anyway...)
good luck....
J Malone |
|
Closed: New threads not accepted on this page