| Author |
Message |
    
no-patience
| | Posted on Wednesday, February 27, 2002 - 06:40 pm: | 
|
Just replaced my clock bulb, with haste removed the cup holder and ash tray.
No clue on how they interface with the dash, I've got these little black spocket things, and I can feel these little switches inside the dash.
Anybody explain how to put these back.
Much appreciation.
thanks |
Mark Meyer (Deadelus)
| | Posted on Wednesday, February 27, 2002 - 07:07 pm: |
|
Mine comes out on its own sometimes.
Just align the "slides" with their respective tracks and push it in till it won't slide in any more. Then push even harder until it catches and won't pull all of the way out again.
Mark |
Anonymous
| | Posted on Wednesday, February 27, 2002 - 07:07 pm: |
|
I threw away my little sprocket things and it works better?
poor spacely sprockets |
Rick Clarke (Tugcap)
| | Posted on Wednesday, February 27, 2002 - 07:29 pm: |
|
Mine jammed, I put it back in, then it jammed again (kids)so I removed it and got the cup holders from Atl. Brit. (the ones that go alongside the trans. hump)they are fine. I never liked they way the dash radio was blocked by the factory unit anyway.
RC |
Neal Glessner (Nealg)
| | Posted on Wednesday, February 27, 2002 - 08:49 pm: |
|
I threw mine away too. PAIN IN THE ASS! |
JRoc
| | Posted on Wednesday, February 27, 2002 - 10:51 pm: |
|
LOL, I'm not alone! I HATE that stupid Fu**ing tray!!! What a stupid place to put the beverage holder! I'm looking into getting those cupholders that screw into the side of the drivetrain hump too. How much does AB charge for them? |
Dave_Lucas (Dave_Lucas)
| | Posted on Wednesday, February 27, 2002 - 11:03 pm: |
|
I got the ones from www.roverconnection.com
They are about the same size hole as the stock Disco II tray, but they mount on each side of the center console and are out of the way.
Look under the disco i or ii they are called "cup holder" and they are $12.00 |
todd
| | Posted on Thursday, February 28, 2002 - 12:44 am: |
|
you can make some out of pvc pipe. Just go to the hardware store with a coke can, find a size that the coke can will fit in, buy about 2 ft., go home and cut to size. This is how I made mine.
Todd |
|
Closed: New threads not accepted on this page