| Author |
Message |
    
Joshua Smith (98hoo)
| | Posted on Friday, September 20, 2002 - 12:40 pm: | 
|
96 Disco with HD OME springs.
I would like to go to 32 X 11.50, and I do not mind trimming the back of the rear fender or the a little on the front. I am worried about rubbing at the top of the fenders, and fitting in the wheel well. Anyone know if they will work? |
Jess Brandt (Disco285)
| | Posted on Friday, September 20, 2002 - 12:46 pm: |
|
i would like to know too...my friend said he give me a set of 5 BFG A/T's @ this size if i can fit them...same set up on a '95....thanks,
jess
please e-mail me with details...i have read a little on offset...which wheels...i need cheap and black...
thanks |
Blake Luse (Muddyrover)
| | Posted on Friday, September 20, 2002 - 12:54 pm: |
|
i had them on my 98 disco OME HD lift and they stuffed fine. The only problem is with the rear panel you would either trim or push it out using the method in the tech section.
I still have my sway bars on , and that might limit the stuffage, but they will fit. also my 32's were super swamper tsl sx and the actual measurement was 31.5 x 10.1 so check your actual tire out and see if they match because tire sizes are gay
and most aren't true |
Joshua Smith (98hoo)
| | Posted on Friday, September 20, 2002 - 01:18 pm: |
|
Should you get 7 or 8" wide rims for 11.50 wide tires? |
Milan
| | Posted on Friday, September 20, 2002 - 03:19 pm: |
|
7" will be perfect but if you plan on going to 12.50 later, get the 8". Either one will work just fine. |
Milan
| | Posted on Friday, September 20, 2002 - 03:21 pm: |
|
Oh yeah. 7" will make the tire a bit taller but narrower than an 8" rim, so take that into consideration as far as fitment goes. |
Blake Luse (Muddyrover)
| | Posted on Friday, September 20, 2002 - 06:58 pm: |
|
mine's on gcr 16x7 |
|
Closed: New threads not accepted on this page