| Author |
Message |
    
BJ Turner (Wturner)
| | Posted on Monday, September 23, 2002 - 08:24 pm: | 
|
Where can a get good, inexpensive 1/2" suspension spacers (NOT Rovertym$$$)?
Thanks |
Blake Luse (Muddyrover)
| | Posted on Monday, September 23, 2002 - 08:42 pm: |
|
Online Metals and order 2 1" inch sections of 4" diameter 6061 aluminum rod. They will cut them to any size. You have to do is drill 2 holes for the bolts. The centers of the holes must be 2.75 inches apart and each is .625 inches from the edge of the spacer. Using a drill-press, drill out ½ inch holes in the spacers. The bolts I used to s ecure the spring perch, spacer and spring retainer were 3/8" coarse thread bolts that are 2.5" long.
http://www.onlinemetals.com/
That was taken from the OME 3" lift in The discweb tech section
it looks like a good start turn 1" to 1/2" and do the necessary changes on the math and ur set |
|
Closed: New threads not accepted on this page