| Author |
Message |
    
Garrett #2
| | Posted on Wednesday, October 02, 2002 - 01:42 pm: | 
|
My ABS likes to kick in all the time now which is scary sometimes when I can't stop the truck. I pulled the 5 amp fuse under the dash a while back but it kept making the check engine light come on so I put it back.
Is there something else I can do to stop this problem and is there a way I can try to fix the ABS??
Thanks in advance!! |
Bill Bettridge (Billb)
| | Posted on Wednesday, October 02, 2002 - 03:22 pm: |
|
Try pulling the 40 amp fuse for the ABS pump which is under the hood - this "should" not activate any light other than the ABS one.
If you've tried the obvious of reseating the sensor - -it is probably a bad sensor - just a matter of figuring out the correct one. Thought I saw a post recently about measuring resistence of each - but don't remember under what thread it was.
Bill |
Garrett #2
| | Posted on Friday, October 04, 2002 - 09:50 am: |
|
Is it best to pull the sensor completely out and clean it and then put it back in?
What is the correct procedure for pulling and reinstalling the sensors?? |
Bill K (Bill_K)
| | Posted on Friday, October 04, 2002 - 11:37 am: |
|
use a flatheaded screwdriver to pry it up enough for you to grab by hand and pull it out. friction is the only thing holding it in. |
|
Closed: New threads not accepted on this page