| Author |
Message |
    
R. B. Bailey (Rover50987)
| | Posted on Friday, October 04, 2002 - 02:58 pm: | 
|
I've got a Taurs Work Light on the rear of my roof rack, I want to use it, I want to actually get it plugged in.
I think I know how to wire it, I just don't know of the best way to get the wires from one place to another.
I am thinking of putting it down behind the rear pillar interior. Then under the carpet in the back and under the carpet in the rear foot well, then up into the center console with a generic switch that looks good. Anyway, how do I go about getting the power from the battery? Access holes in the firewall? Best route to take? Best place to find the correct switches?
Thanks |
Mike B.
| | Posted on Friday, October 04, 2002 - 09:24 pm: |
|
Check out www.discocrazy.org under the Vehicle Mods section. I ran the wires to the front of the roof rack and down the A pillar to the engine compartment. I ran the hot wire from the fuse box in the engine compartment to a relay and then to the lights. I ran the hot for the relay in through the firewall just below the windshield wiper resevoir.
Thanks,
Mike B. |
|
Closed: New threads not accepted on this page