OK, I officially need serious help now. I am so far out of my depth it's not funny....
I made up the cable and hooked up the PC to run the freeware and it revealed a litany of errors.
F8 = 69
F9 = 227
FA = 213
FB = 0
FC = 255
FL signal incorrect
FR signal incorrect
RR signal incorrect
Engine speed fault
Vehicle speed fault
Air supply leak
Target heights incorrect
Vehicle has moved
Cannot lower FR
Cannot lower FL
FA:16_Hidden
FA:64_hidden
FL valve stuck closed
FR ditto
RL ditto
RR ditto
Inlet valve stuck closed
Exhaust valve stuck closed
FC:64_hidden
FC:128_hidden
Each time I run the program, it has different errors.
When I read the heights, I get
HIGH Profile: FL = 0, FR = 6, RL = 0, RR = 14
STANDARD Profile: FL = 0, FR = 0, RL = 0, RR = 247
LOW profile: 0, 0, 0, 14
ACCESS Profile: 0, 0, 0, 247
and, if I do them again, they are different again....
When I "get sensor heights"
LF = 128, RF = 40, LR = 128, RR = 40
and, if I do them again, they are different again....
As for the " Cannot lower FL and FR in the errors, I set sail to town this morning to buy the bits for the cable and having manually inflated the old girl to approximately level, I plugged the valve body and compressor in, turned the key to start it and, as soon as it started, it dropped the front onto the bump stops. I limped to a service station, inflated the front again and as soon as I started it, back on the stops.....
I unplugged it all, inflated it again and ran my errands, came home and got the errors above when I fired the PC up.....
So, where do I even start debugging this shambles?
I made up the cable and hooked up the PC to run the freeware and it revealed a litany of errors.
F8 = 69
F9 = 227
FA = 213
FB = 0
FC = 255
FL signal incorrect
FR signal incorrect
RR signal incorrect
Engine speed fault
Vehicle speed fault
Air supply leak
Target heights incorrect
Vehicle has moved
Cannot lower FR
Cannot lower FL
FA:16_Hidden
FA:64_hidden
FL valve stuck closed
FR ditto
RL ditto
RR ditto
Inlet valve stuck closed
Exhaust valve stuck closed
FC:64_hidden
FC:128_hidden
Each time I run the program, it has different errors.
When I read the heights, I get
HIGH Profile: FL = 0, FR = 6, RL = 0, RR = 14
STANDARD Profile: FL = 0, FR = 0, RL = 0, RR = 247
LOW profile: 0, 0, 0, 14
ACCESS Profile: 0, 0, 0, 247
and, if I do them again, they are different again....
When I "get sensor heights"
LF = 128, RF = 40, LR = 128, RR = 40
and, if I do them again, they are different again....
As for the " Cannot lower FL and FR in the errors, I set sail to town this morning to buy the bits for the cable and having manually inflated the old girl to approximately level, I plugged the valve body and compressor in, turned the key to start it and, as soon as it started, it dropped the front onto the bump stops. I limped to a service station, inflated the front again and as soon as I started it, back on the stops.....
I unplugged it all, inflated it again and ran my errands, came home and got the errors above when I fired the PC up.....
So, where do I even start debugging this shambles?