K-rover....what "specs" do I need? What compressed and extended length do I need?
To get the best performance you need to take a measuring tape and crawl under your truck. Every lift is slightly different. I have 11" fox emulsion 2.0's with a 4" lift. I could have ran 12" shocks, but as it is I dont use all 11" of travel. Even with the rear panhard bar. I would guess 10" or 11" would work for you, but you need to measure to make sure. You need to make sure that you are not over extending or bottoming out your shocks. The ESHOCKS page gives you all the dimensions so you can compare that to your measurements. Then the next question is valving.. I cant remember what valving I got on mine. You can probably search here and find out what most people are running. The valving numbers are proprietary to the manufacturer. So the numbers for Fox wont match the numbers for Bilstein. (FYI)
THe fox shocks require trimming of the rear upper mounts and removing the captive nut from the bottom. You will also need the step down spacers for the rear uppers.
The Bilstein should fit witout trimming, but I cant confirm that.