Has anyone purchased from UltraFlex4x4? I've tried to contact them regarding their LED headlight conversion kit, but I'm not able to reach anyone from the company. Also, does anyone have experience with their LED headlights? I'm considering them for my D1.
Cheers,
Casey
Previous owner has a kenwood radio installed in the 98 D1, and I’m wanting to remove it so that I can have access to wires behind it. I’ve gotten as far as the attached photo indicates. The remainder does not appear to “pop-out,” and the two screws below it appear inconsequential to its...
I run 265/70r18 Falken Wildpeak tires on my LR3. Load Range E. I use a 30mm wheel spacer. I’m not certain that wheel spacers are necessary. I also chopped my front frame horns, so no rubbing there.
The tires have worked well for me. I air down to 20psi (in my LR3) regularly while...
Remove them, then paint the metal rail black. This is what I did on my D1 and it looks great. Plus, you won’t need to worry about rust developing under the rail trim.
1998 D1 w/ 4.0 engine. Power steering pump is leaking at a part that connects the pump to the large-diameter hose that runs to the reservoir (see attached photos). Is this part (I don’t know its name) removable and re-sealable? If so, whats its name, how do I remove it, and what replacement...
Attached are photos of the rack. It had not been cleaned/washed, so there are bugs/dirt on it. What can I say… I live in the desert and 4wheel a lot : )
Selling a Front Runner Slimline Rack for an LR3/4. Comes with a wind fairing and crossbars to mount a rooftop tent. $1000 obo. Location: Borrego Springs, CA.
Cheers,
Casey
Will be moving to the greater Salt Lake City area in a month. Can anyone recommend a quality independent Land Rover mechanic (for a D1 and LR3) in Northern Utah?
Note: I do not want to take my vehicles to GBR.
Thanks!
Heading to the LR National Rally and one of the hoses (transmission cooling?) in my 2007 LR3 (150,000 miles) has begun weeping. It’s pictured below the engine oil dipstick and is slightly illuminated by my flashlight. Can anyone definitively identify the hose for me? If you happen to have a...
Greetings,
I'm looking to purchase a full-size roof rack to fit my 1998 D1. I'm currently in California, but am willing to travel to AZ, NM, CO, UT, NV to get it. Perhaps, you also have a rear ladder?
Thanks!
Greetings,
I'm getting two codes on my 1998 Discovery 1:
P0150 - O2 Sensor Circuit Bank 2 Sensor 1
P0130 - O2 Sensor Circuit Bank 1 Sensor 1
Has anyone received both of these codes together, and, if so, was the fix to replace both O2 sensors, or might the problem be different or more complex...
I'm wanting to replace much of the drip rail moulding/trim on my 1998 Discovery 1. If you have any pieces available, please let me know. Also, if you have any suggestions for generic alternatives I could use to produce my own moulding (in the event that I can't find any OE moulding for sale)...
Greetings folks,
I'm getting ready to flush my cooling system, and I have heard that, instead of pulling the lower radiator hose, vinyl tubing can be inserted down the upper radiator plug hole and then the other end of the vinyl tubing can be sucked-on until the coolant begins to flow. Of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.