Cracked tank is certainly a possibility. Only leaks when engine is running. How should the hose be routed then? I didn't adjust that hose routing . It's been that way for a long time and that line running to the throttle body is not very flexible so not sure how big of an adjustment I could...
2000 Discovery 2
134K
Just replaced throttle body gasket with kit today because I know they fail and it had a slight leak.
I have had an on going coolant leak issue and after doing the throttle body today and starting the truck back up I noticed a pretty substantial drip from what appears...
This leak has me confounded. Can't see any fluids on the ground nor in engine compartment. I don't have a pressure tester. Overflow tank has been low. I filled up to cold level. Son drives to school on secondary roads about 20 miles round trip. Coolant level drops only after a few days...
What coolant for my Disco 2?
I used the Land Rover XLC last time but now I have a leak. Still diagnosing the issue as the expansion tank only seems to go low after a few days. I have a new cap on order to test that first. Meanwhile need to know what pre-mix 50/50 solution I can use to top...
Got her done. Not too bad.
70mm idler pulley goes under the tensioner pulley, Larger goes up top near the alternator.
Hardest part was tightening the fan nut. I went ahead and removed it. I have the 36mm wrench for the fan nut but no tool to hold the flywheel bolts in place. just...
Water pump done at 105K miles so hopefully that's not the culprit. I have 135K on the truck now. Was done back in 2008 so not sure if time is a factor.
Still can't find the torque settings in Rave manual. Saw a you tube video of the process. Stated 37lbs for both the idler pulley bolts and...
Hi,
2000 D2 134,500K
Got some chirping going on and figure these boys need swapping out. I bought the kit from Atlantic British.
https://www.roverparts.com/engine/kits/ERR6439K/
How hard a job? Tips, tricks? Torque settings?
Thanks
So I passing the old 2000 DII ( 131,000 ) onto my 16 yr old son. Going on 23yrs old now I'm gonna need to replace some hoses etc. I've done alot over the years but lots of original parts.
First task I believe will be the power steering pump. It has never leaked but I am worried about the...
couldn't tell if there was coolant in the oil. It looked clean. Not sure how to tell that.
On the other hand the coolant level is a little low so it maybe leaking
Truck starts fine and idles fine. After driving for just a few minutes is when the sputtering starts.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.