Search results

Any 94/95 owners do this conversion with a earlier chev 350 carb’d 5.7 motor? Looks like it bolts right up. https://www.marks4wd.com/mfp410la.html Thanks in advance! hunter 95 disco with ailing 3.9

Looking for one in southeast or mid Atlantic. Thanks, Hunter

Looking for at least two for front. Thanks for looking. Hunter

Hey guys, this is a '95. I am looking for it's paint code to respray hood. Went to my dealer in Charleston with the VIN but they ran it and said the paint code didn't show up. Any ideas? Thanks, Hunter

Hey guys, Will any D1 (94'mid 2000) transmission (ZF) be compatible with a 1995 D1 or just a 94/95 ZF tranny. Searched around but couldn't find it. Thanks, Hunter 95 D1

Contact me if you'd like to sell! No major dents please. Thanks, Hunter

Hey guys, Sent 2 diffs to these guys (who had done an ARB install for me before) and its been 4 weeks, and now they're not answering the phone or calling me back. Anyone have any insight? Thanks, Hunter

Anyone know the carrier bearing (TIMKEN or other) part # for a 91 RRC Tru Trac carrier? My intaller is having issues getting the bearings to fit. Thanks! Hunter 91 RRC PS you may see a similar thread on the Disco forum , but this is a 2nd truck

Anyone know the carrier bearing (TIMKEN or other) part # for a 95 D1 Tru Trac carrier? My intaller is having issues getting the bearings to fit. Thanks! Hunter

If you were changing out your front 3rd member to a trutrac, would you swap to the 24 spline axles or stay at your stock 10 splines? (91 RRC) I thought I read somewhere that the 24 spliners were stronger, but I could be wrong... Thanks! Hunter

CV/Axle stuck in 3rd Member Searched the archives, Someone will have an easy answer: Pulled everything down to the outer axle on both front ends. One outer axle and c v pulled out no problem (drivers) The other (where I think the cv is shot) won't pull out. What's the best way to pull this...

group, can a battery be so dead that even when jumping off another vehicle, it doesn't have enough amps to crank? how do i reset/disable the theft control on a d1? the light below the radio is flashing which i don't know if its affecting my ability to start. took the horn fuse out as every...

Will an emu 2" lift from a 97 D1 fit a 91 rrc (as in the perches and such)?? thanks! Hunter

Looking for a 2 inch lift kit for a classic Range rover. Call Hunter; 843.901.0470

Hey guys, Helping a friend drop a 91 RRC ZF off the engine to replace the tranny. I have EVERYTHING unattached, and want to know how many bolts are used to attach the transmission (bellhousing) to the engine. I can only find three I can reach from underneath (2 drivers side, 1 pass side). Is...

For Sale: (To buy a diesel truck to tow) (yes I'm keeping my other disco) The Good-- 1994 Manual D1 123,300 My daily driver New updated transfer case 6 mos ago Well maintained Good Shape Runs Like a Top Paint - Fair to Good Warn Winch M9000 (may need new solenoid, I haven't tested it) ARB...

Hi, 94 D1 Manual Have done a search and think i have a fuel injector leak. Symptoms: crank, no start, but when finally started after giving gas, runs perfect. Changed fuel filter already. Starts easier first thing in am, rather than 5 mins after running. No codes thrown. So i think (from...

So you know the gentle hum or whine at the back of your D1 that is usually barely audible? Mine has gotten quite loud, and i'm wondering what this represents. The sound is not affected by rpms or movement. It increased in volume after driving abt 2 hrs down to kiawah last weekend. Any ideas...

Anyone coming through (or leaving) Columbia SC on Friday am to go to the MAR? Was looking to organize a caravan for the ride up. Hunter

Hey guys,gals, What's an algorithim for troubleshooting a warn winch that won't work? All leads are hooked up, which parts do i need to check in the solenoid to see if it's getting power properly? I tried connecting the solenoid contacts by NOT using the remote on the solenoid (ie took a...