Search results

I have a complete DII CDL shifter kit from a DI for $100 delivered to the lower 48. Comes with boot and instructions. The DII it was going in burned. :eek: :eek: email or PM Rob

I have an '05 LR3 with the factory trailer light harness installed by my dealer. Trailer tail lights worked when new. My manual shows a small fuse panel behind the left rear tail light in the same area as the trailer wiring harness connectors, but the panel does not exist and the wiring...

I am getting close to needing to replace the rear brake pads on the 05 LR3. I am trying to consolidate the info needed to do this DIY job here in the LR3 forum. Does anyone have the torque specs for the caliper bolts and bracket bolts? Does anyone have the spec pad thickness for changing...

Where are the older threads in this forum? No page 2?

I was riding offroad yesterday through 12 miles of lowlands with frequent wading (fresh water) up to hub height on the way to a nice sand point on the bay. I have had 2 previous "Suspension Failures" which I associated with water crossings but the Tech at the dealer says he did not think they...

Rebuilding the front driveshaft on the 99 D2. There is a small hole in the flange that the ball joint mounts on. This appears to be cast in, but I cannot be sure. Is there supposed to be a "vent" hole in the flange under the ball joint?

Just installed an ARB Bull Bar and a Warn XD9000 on my '05 LR3. The positive connection for the winch is easy. Where are people connecting the negative lead? I found a couple of chassis grounds but would rather have it connected to more substantial ground. I can't see an easy way to properly...

Need to remove the Air Filter Box in the 99 DII. As usual, RAVE has complete and detailed instructions consisting of "Remove the Box from the Grommets" with no real explanation. Did a search and could not find anything. Before I pull really hard and break something, is there a trick to...

Has anyone fitted the LR3 Safari Snorkel to a petrol V8? Safari is non-committal on if it will fit per their emails to me and others. I am not interested in the G4, even tough it looks better, because it is not water tight. The goal is to keep muddy splash water and "oh CRAP, where did that...

3/16 steel and welded 3 side box. No urethane. Seem pretty substantial, but I can see the weak point. Look to be easily repaired or bypassed if you wanted. Received 03 Jan 2008.

Moderators, please review this members 7000+ posts. He has nothing but negative input and does more damage to discowebs reputation than anyone or anything else. Rob

When my DII is warmed up, the coolant level is almost out of the expansion tank. When I loosen the cap to add coolant, it flows back in and up to a normal level. No loss of coolant that I have been able to detect in a few hundred miles. Is this a sign of trapped air in the system? What is...

I know the horror stories, BUT there are good dealers out there. Who has had a good experience and where is that dealer? City, State/Provence, Country

I have a totaled 99 Range Rover in my drive. Good engine and everything else except body damage caused it to be totaled. I am thinking of buying a 99 Disco 1 with a bad engine. Could I swap out the engines, computers, wiring harness and everything and make this work? I am not wanting to go back...