I had a few days off so I hit Moab. Going down Kane creek and the alt bearings making a lot of noise. I turn around go to town order a new alt and camp on Kane creek. the next day replace alt no problems. We were running Kane Spring Road and made it through about 3\4 of the trail. I started up...
OK late nighters
My key wont go into the ignition cylinder I do not see a section in the book for the ignition and the search leads me to bypassing the ignition. It looks like there is a ball, that has a hole in it that needs to slide over to allow the key in, that has turned and does not...
Ihave read the tech on the front bearing. Did a search but no luck. 97 d1 manual. I have a lot of noisein the rear. upon inspection I can move the rear driveshaft up and down. The ujoints look good but the e-brake drum moves ~1/16 inch or so. I have not pulled the e-brake yet. Can I replace the...
Ok I did a search and found this by Mark Olivares
5" springs need about 6 degrees of caster correction
3" springs need about 4 degrees of caster correction
but both of these arms will put the pinion flat, which would create vibes w/ a DC shaft.
My question is, is there a formula for this or...
Noise comes from transfer case area when I let off the throttle. Goes away when throttle is on and gears are under torque. This is not a gear noise that is continuos or noise that happens under power. Is there a transfer case rebuild kit for my 1996 Disco?
Research tells me that this is a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.