Search results

thanks DiscoStew. Sounds like I have some fun ahead.

I ordered an o2 from AB and installed it just to rule that out (even though Im sure it wasn't the issue) and again got the 1173 code. Is there somewhere else I can test to try to figure this out. I can't pass emmissions with this issue and can't legally drive the truck till I do.

I got the P1173 code today while driving. Which make sense given the readings, but if its not the sensor what do I need to be looking for?

So I tested as suggested. After it got down to 0 I unplugged the 02 but there was no change. it just stayed 0. Does that help lead us down a path of something else to test?

Thanks. I will test shortly.

When you say "one of the sensors" do you mean on that is functioning correctly or the one that is not functioning correctly? Only them rear passenger side is not functioning correctly. Thanks for the help!

I have reconnected the wires and am getting the same problem. Regardless of the O2 being connected, it will .4 and then slowly drop to 0 and stay. While I had the wires apart, I had to drive the truck to go pick up kids from school one day, so i tucked it up and monitored to see what readings...

I have bought from him before too. Very helpful and quick delivery. I would recommend.

I didn't use anything on the connections. Last night when I finally got a chance to put the multimeter to the plugs to test, I realized that the obd2 was still reading voltage even when the sensor was unplugged. I am going to pull the wires and redo connections. I am guessing that one of them...

I've tried both and it's consistent in driveway and on the road.

OK. So I have spliced in a new plug. Which got the O2 responsive again for about 4 minutes. Now it will start fine (when cold) and register .4v. Then about 3 minutes in it will drop to .3, then .1 and then 0. It will remain 0 for the rest of my drive. If I let it sit 30 minutes or so then it...

I have an 02 sensor that is intermittently working. I need to splice in a "new" plug. Shipped to 30318. If it could have plenty of wire left to give me some grace while splicing I would appreciate it. :)

I swapped in the other new Bosch o2 sensor and again it's unresponsive after a few minutes of driving. The wires go over the transmission. Is that right? I'm thinking the transmission heats up and causes the wire not to respond. Any one have a suggestion?

K-Rover - By replace, you spliced in a new clip or did you trace it back further?

I have replaced all of my O2s with new Bosch sensors. I am having one sensor that was fine, but now when it will go unresponsive after driving for a few minutes. The Downstream passenger side sensor is responsive when I turn the truck on and while its idling in the drive way. It will work for a...

sorry posted in the wrong category! please delete

I need the small black "buttons" used to secure the seat back of the jump seats to the chair frame. Probably need about 8-10 as both are just hanging on right now. Shipping would be to Atlanta, GA 30318 Anyone have some laying around?

Sure I appreciate you showing me that thing called Google. I'll make sure to use it next time rather than asking here.

I don't believe I have an exhaust leak. Sounds fine to me. Yesterday while driving it to try to watch the O2 activity, It threw P0150 a couple times. I looked in Rave, but don't understand if this is a fault with the actual sensor or what it's connected to? At this point I am thinking I need to...

hmmm thats an interesting idea discostew. I ended up taking it to a LR/BMW local small shop and they ran diagnostics and a smoke test and it didn't throw any codes for them and didn't leak for them either. However after leaving the shop after putting another 30 miles on it (to get enough to...