Search results

Thank you.

Any experience with Euro-Tek in Wilmington?

Any good shops between Wilmington and Jacksonville North Carolina?

Last fall my wife pulled out of the driveway and left a puddle and stream of fuel in her wake. Brought the car to my local indy who fixed the problem by replacing and installing LR043420. I then get the recall standby notice. Then get the recall notice with the offer to reimburse already...

$75 shipped

Bump

Bump

Used for about 14 months. In very good condition. No rot and hold air well. $100 shipped.

This is the Hi - Low transfer case shift cable from a 2000 D2. The action is very smooth. In good shape. $130 shipped.

It’s been a long while, so resurrecting this discussion since I’m in the market for a front DS. Anything new on the Tom Woods vs GBR debate?

This

Any Kalahari’s?

I'm looking for a used steel rear bumper for a D2. Let me know what you have. Thanks.

Thanks. Clearing ABS is key with a Disco.

The purpose is to clear codes/faults.

Looking for ideas on a device to clear codes on a D2, such as the three amigos or check engine. I have a nano that I use for the P38 and Disco, but want an inexpensive device to leave in my son’s Disco. Thanks.

Interested in the 16”. Will let you know what I might need. How much? How’s the condition?

Do you have any of the 03-04 Disco six spoke wheels?

Thanks for looking Will. If any seem to have not butchered their original harness and instead used adapters that would be nice.

With the typical disclaimer "your results may vary", I've had success twice sourcing used motors. The first was a slipped liner in my '98 P38 at about 180,000 miles. Found a used 75k motor for $1,200 and 60,000 miles in it's solid. Same deal with my son's '00 D2. Cracked block at 90,000 miles...