Seems like to most I can get out of a window motor is 2 years. I have changed this so many times. Has anyone has success with a particular brand? I purchased the last one from a reputable dealer (that posts here on discoweb) and it lasted just short of 2 years. I cannot find any brand name on...
Special Ed,t of the engine.
Thank you. This is not the strap. That strap is there and is considerably smaller. (Driver's side - head to firewall). This was found in the front of the engine.
Doing a head gasket on my 2002 Disco. My son pulled this out of the front of the truck. Can anyone tell me where this strap goes from and to? It's about 12 inches and seems to be broken
Thank you everyone for your help. I had new top hat liners installed from Turner Engineering about 7 years ago. I'm assuming it's a head gasket. Pulled the heads and are having them serviced. Hope to have it all buttoned up in a week or so. Also bought an ignition coil re-locator kit. (Wish I...
Henry, I pulled the engine with the help of my son and we brought it to the machine shop attached to the Napa on Six Forks road by Wegmans. I bought a set of top hat liners and had them installed.
I apologize for this question but I have never used a pressure tester before. Since the intake manifold is removed shouldn't I have to clamp off the coolant lines before I run the pressure check?
2002 Disco - I pulled the intake and there appears to be a puddle just behind the alternator on the passenger side. Photos attached. Anyone have any idea where this leak might be coming from? It is leaking pretty heavy coming down the back on the end on the passenger side.
2002 Disco2. Coolant leaks back of the engine so that it drips on the passenger side catalytic converter. I can't seem to be able to trace where it is leaking from. Only leaks when it gets up to running temperature. In fact, it didn't leak until I switched on the AC. Any idea?
My son was struck in our 2002 Discovery. It was a low speed accident but truck was pushed over and it's side. Tow truck pulled it upright after about an hour. Truck stutters now. Was wondering if there is anything obvious I should be looking at or changing.
To change lock on driver's door. After you remove the handle. Then unscrew the phillips screw on the inside of the handle and then remove the circlip and washer on the end of the key barrel. Then pry the rectangular out side cover. It just prys off. PUT THE KEY IN THE BARREL and leave it...
Son had an accident and car landed on it's side. Drivers door handle is mangled. I'm buying a used door handle. Is there a way to transfer the lock mechanism to the new handle?
2002 Discovery.
Was receiving a consistant OBD code for the CPS. Was told it was the wiring/connector by a land rover shop. Spliced a new wire into the wiring loom and used an aftermarket connector. Wouldn't start after that. Brought it back to the shop and they said the CPS wasn't receiving...
Mine were really stuck on there and ended up twisting the pipe. Sourced a used on from Will Tillery. (Cut the pipes with a sawzall and removed nuts with a socket.)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.